0
To change the thermostat in a 1991 Mazda B2600I, first, ensure the engine is cool and disconnect the negative battery terminal. Drain the coolant from the radiator, then remove the upper radiator hose and the thermostat housing. Take out the old thermostat, clean the mating surfaces, and install the new thermostat with a new gasket. Reassemble the housing, reconnect the hose, refill the coolant, and reconnect the battery before starting the engine to check for leaks.
What else can I help you with?
Where is the fuel pump on a 1991 Mazda b2600i?
Where is the fuel pump located at in a 91 Mazda b2600i
Where is the fuel filter on a 1991 Mazda b2600i?
on the firewall passenger side
Fix leaking break caliper in 1991 Mazda b2600i?
just replace the whole caliper.
Where is the pickup coil on 1991 Mazda b2600i?
The B2600i does not have a pickup coil, it uses a hall effect sensor located inside the distributor to trigger spark. K6 Mazdatruckin.com
How do you repair a clutch in your Mazda 1991 pu b2600i?
See if your public library has a Chilton's for your car to replace the clutch.
Under hood vacuum line schematic for 1991 Mazda b2600i?
Mazdatruckin.com has a schematic for the B2600i vacuum lines in their tech section, it includes 4wd and cruise control devices. See the attached links below.
How do you check the timing belt on a 1991 Mazda B2600i?
There is nothing to "check". Look in the owners manual and change the belt according to the service requirements. They never "look" bad until they fail and destroy the engine.
Where is the thermostat on a 1991 Mazda b2600?
follow the upper radiator hose
Could the rod for the jack on a 1991 Mazda b2600i truck fit the hoist for the spare tire?
Very possible. That info could be found in the owners manual also.
What is the wiring sequence on a distributor for a B2600 1992 Mazda pick up?
Firing order is usually 1-3-4-2. So start from the front of the pickup, going clockwise. (mine is a 1991 Mazda b2600i).
How long does it take to change the thermostat on a 1991 Mazda 626?
i would say 30 - 45 minutes to leave a good amount of time. maybe 1 hr if you have problems
What is the radio wiring for 1991 Mazda B2600i?
Attached in the links below are diagrams for the factory radio and the related dash panels to remove it. I've also posted some additional links for future reference.
