To replace the gear stick knob on a Fiat Scudo, first, ensure the vehicle is in the neutral position. Carefully pull the old knob upwards to remove it; it may be held in place by clips or screws. Align the new knob with the gear stick and push it down firmly until it is secure. Finally, test the knob to ensure it moves freely and is properly attached.
remove the black plastic breather (17mm) and refill with 2lt of gear oil after draining the old oil from the gearbox using the drain plug on the bottom of the box (21mm)
can anyone advise me my fiat barchetta is judering in first gear
pull up gear stick nob, then low end of gaitor pull out of center,middle. first one side then other side
It may be the ball locking mechanism(it helps the gear stick stay in place on not jump out of gear) that is found under the gear stick or on the transmission. You may need to replace or it could just been loosen of.
unclip the gear stick leather gater and it is accesable from there
linkage is sticking
To change the gear oil on a Fiat Punto 60, first locate the gearbox, which is typically found beneath the car. Remove the drain plug at the bottom of the gearbox to allow old oil to drain out completely. After draining, replace the drain plug and refill the gearbox with new gear oil through the fill plug, usually located on the side of the gearbox. Ensure to check the owner’s manual for the correct type and amount of gear oil to use.
id recomend a david brown 995 gear stick they work well!!
The gear stick has a diagram of where to move the stick to engage a certain gear. For example, if Gear 1 is in the top left corner, you must move the stick to the fair left, then forwards to engage first gear. Oh, and you have to push down the clutch each time you change gear.
There are usually no lights or meter for gear oil. In old automatic gear boxes you have a dip stick to check the oil levels. New automatic gear boxes can be a sealed unit, and manual gear boxes you have to open the drain plug, and replace the oil.
The synchro cones in the gearbox are worn. Either a strip and replace or a whole gearbox swap is the cure.
To remove the gear stick on your Polo, first, ensure the car is in neutral and disconnect the battery for safety. Next, carefully pry off any surrounding trim or covers to access the base of the gear stick. You may need to remove a retaining clip or screws holding the gear stick in place. Finally, pull the gear stick upward to detach it from the transmission lever.