Check engine mounts (damaged or broken) if they are ok then check for oil contamination on clutch plate.
what gearbox oil for ducato 2.8 jtd
To replace the gear stick knob on a Fiat Scudo, first, ensure the vehicle is in the neutral position. Carefully pull the old knob upwards to remove it; it may be held in place by clips or screws. Align the new knob with the gear stick and push it down firmly until it is secure. Finally, test the knob to ensure it moves freely and is properly attached.
80-90 Gear oil
you can try wynns gear leak stop-it thickens oil and swells the seals.
Incorrect gear ratio in first gear.Incorrect gear ratio in first gear.
I've never heard of a 'clutchwhy'. What is it?
if you have selcted the gear and setting off and it sounds like grinding the gearbox is on its way out. but if it is grind ing when selecting gears its your clutch not realising properly which could be your master cylinder this only happens if your clutch pedal only as half of its full raise. but if this is not the case, it could be the clutch... but i would try putting gear oil in first in all the cases i have mentioned.
Yes, a Fiat Brava gearbox can generally fit a Fiat Bravo, as both models share similar platforms and components. However, it's important to verify compatibility based on the specific engine and model year, as variations may exist. It’s advisable to consult a mechanic or refer to manufacturer specifications to ensure proper fitting.
Capacity is 2.75 litres to much and it will blow out through breather on gearbox
bog down in first gear and then it strtes to shift
The Fiat Uno 1.1 Fire (Fully Intergrated Robotic Engineering) motor is the same in the Fiat Punto 1.1. The torque settings as per Autodata is Camshaft carrier cap - M8 x 1.25 20Nm or M8 10Nm Camshaft gear - 70Nm Anything else, just ask