A special tool is required to separate the lines after the retaining clip is removed. They are relatively inexpensive and Auto Zone sells a set of these AC line separators for around $10.
The 1973 Chevrolet El Camino dashboard is held in place with 12 retaining bolts. Remove the retaining bolts and the dashboard will come off. The dashboard will be into separate pieces.
The 1996 Chevy S 10 pickup truck bell housing is held in place with eight retaining bolts. Remove the retaining bolts and the bell housing will separate from the transmission.
To remove the bottom of a glass bottle, you can use a glass cutter to score a line around the bottom, then apply hot and cold water to the score line to create a crack and separate the bottom from the rest of the bottle.
The Chevy Lumina dashboard is held in place with retaining bolts and retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
To remove the washer bottle from a Ford Ka, first, ensure the vehicle is off and the keys are removed. Locate the washer bottle, typically found near the front of the engine bay. Disconnect the washer fluid hose and the electrical connector from the pump, if applicable. Finally, unfasten any retaining clips or bolts securing the bottle and carefully lift it out.
You will need to remove the transmission. Remove the clutch plate retaining bolts. Remove the clutch linkage. Remove the clutch retaining bolts.
The 1995 Chevrolet Lumina dashboard is held in place with for retaining bolts and 12 retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
The 1997 Chevy Cavalier dashboard is held in place with for retaining bolts and eight retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
Have an ASE certified technician in an EPA certified service shop do it. This task involves recovery and storage of the refrigerant in the system - purging the system in a manner which releases it into the atmosphere is illegal under federal law. Then the accumulator can be removed. If you remove the accumulator, you'll need to replace it.
Remove the decorative radio retaining plate. Remove the radio retaining screws. Remove the wiring harness, from the back of the radio.
To be able to remove the hose off of the accumulator, you need a special quick disconnect tool to remove the hose off of the accumulator. Can be found at your local parts store. Its gonna be big in diameter. Might want to get a assortment of sizes ranging from 1 inch on up in size.
Remove the decorative radio retaining plate. Remove the retaining screws. Pull the radio out. Remove the wiring harness. Remove the antenna cable.