To set the time clock in a Mazda CX-9, turn on the vehicle and access the infotainment system. Navigate to the "Settings" menu, then select "Clock." From there, you can adjust the time manually or set it to sync with GPS, depending on your model year. Make sure to save any changes before exiting the menu.
Hold the clock button in the use the the radio seek button to increase or decreas the time.
the clock is set for time
Press and hold the clock button to the left of the display until the selection for 12 or 24 hour time comes up (note 24hr time is military time)...after selecting 12 or 24h, the hour should be blinking, press set for each hour to increase, press clock to change to the minute selection and press set to increase the minutes, press clock when you are done.
How do you set the time on a S10/Scan atomic clock model 86715
To set the clock in a 2002 Mazda MPV, turn the ignition on without starting the engine. Press and hold the "Clock" or "H" button until the hour digits start flashing. Use the "H" button to adjust the hour and the "M" button for the minutes. Once set, press the "Clock" button again to confirm and exit the setting mode.
How to change Mazda 3 Clock settings To set the hour: 1) Put ignition in ACC or ON position 2) Press and hold "CLOCK" until beep sounds and "12 hr/24 hr" is displayed; 3) Press "SET" to select 12 or 24 hours (24 hours is military time) 4) Press "CLOCK" again while the selection is flashing "Hr ADJUST" 5) Press "SET" to select hour 6) Press "CLOCK" when done Do the same to set minutes, but select Minutes in step 4
How do I set the time on the clock on a 1995 Mercedes C220
uhm i dont think you can set an alarm clock, but you can have a clock on your zune. go to settings and scroll till you see clock, click 'show clock' to yes and set the time to either 12 or 24 hour setting then set your time
The first time set on a clock is typically 12:00 AM, which represents midnight.
how to time set up ajantha degital clock model no: olc 103
Press and hold the clock botton. After the beep, both hour and minute values will be blinking. You can then set the clock by pressing the H for hour or M for minute.
To set the time on a Dreamer Clock, first locate the "Set" or "Time" button, usually found on the back or side of the clock. Press and hold this button until the display starts blinking. Use the hour and minute buttons to adjust the time, then press the "Set" button again to confirm your changes. Finally, ensure the clock is set to AM or PM if applicable.