0
Eg volkswagon has a timing belt and a pulley tensioner that make the car run if they go your car won't work. They are supposed to be replaces every 100000km and when you replace one you replace both of them along with the watercpump because the labour is expensive and you don't want to have to pay to do it again in a month
What else can I help you with?
Are belts a pulley?
no belts aren't a type of pulley
What is the purpose of a crankshaft pulley?
To drive the belts
What happens when pulley belts get to tight?
They snap to the max.
What does it mean when there is a clunking sound coming from whhel that turns belts in the engine?
I'm assuming you mean a pulley, which is what the belts run on. If so, depending on which pulley the bearings could be bad or if it is the crankshaft pulley (big pulley near the bottom) the rubber could be getting bad.
How do you install fan belts on a 92 landcruiser?
Put the new fan belts around the fan pulleys. Slide the top tensioner pulley upward. Tighten down the tensioner pulley when you have achieved the proper fan belt tension.
Pulleys and belts will result in the fastest rotation?
Large drive pulley, small driven pulley = faster rotation but less torque. Small drive pulley, large driven pulley = slower rotation but more torque.
Where is the crankshaft pulley located on a 1997 Ford Mustang?
bottom of engine where belts go
How do you remove the crank pulley on Mitsubishi 3.0 v-6?
remove all belts,tensioners etc, remove pulley bolt, use HARMONIC BALENCER PULLEY to remove - DO NOT USE NORMAL PULLEY REMOVER - must be pulled from center of pulley not from outer edge
How do you change front crank seal on a Nissan sentra 1.6?
Lift car on jack stands, remove right wheel for better access,remove any belts, remove pulley bolt, then use a pulley remover to remove pulley, carefully pry out old seal thebn tap in new seal with mallet or plastic hammer, if pulley has ridges on it you may have to replace pulley or you might still have leaks. reinstall pulley,bolt, belts and wheel. Good Luck.
What are the fan belts for on a 1993 Nissan Serena van?
First of all, they are the same as the fan belts on any other car. The fan belt(s) are the serpentine drive belt(s) that turn your fan and other accessories (like alternator, compressor, power steering) They are often referred to as serpentine belts, drive belts, and accessory drive belts. The are located on the outside of your engine, driven by the main pulley (crankshaft pulley). R. Mesyef
What is a tool that transfers energy?
A pulley is a tool used to transfer energy mechanically. It can transfer energy by lifting or moving objects using a system of ropes, belts, or chains.
Ford 5.8 V8 marine braking alternator belts?
If you have a Mercruiser, there was a recall on the pulley that was first used. As I remember, the pulley was wearing out the belt prematurely causing it to break, and or jump off. I would check with a Mercruiser dealer to see if applicable to your engine.
