51 FT. LBS.
Main caps should be torqued at 76 foot pounds for the 22r.
80Lbs for flywheel, 10 to 15lbs for pressure plate
get specs from your local librarys technical isle look up specs and tightening sequence.
To replace the throw-out bearing in a 1986 Toyota 22R pickup 4x4, first, disconnect the battery and remove the transmission by unbolting it from the engine and supporting it with a transmission jack. After removing the clutch assembly, take out the old throw-out bearing from the clutch fork. Install the new throw-out bearing onto the fork, reassemble the clutch and transmission, and finally reconnect the battery and test the clutch operation. Always refer to a service manual for specific torque specs and detailed steps.
i would sayy 40 is good enough !
19 lbs on the studs, and 30 on the nuts.
Improve13 ft lbs but tighten gradually from the center out to each side.If you number them 1-5 tighten them as 3-2-4-1-5...Read more: What_are_the_torque_specs_for_a_2001_Toyota_Tundra_intake_manifold
.0010 - .0022 in or .025 - .055 mm max limit is .0031 in or .08 mm
To set the timing on a Toyota 22R engine find the distributor. The engine will have marks at which the distributor can be set. The OEM setting for a 22R engine is 5 degrees.
1986 is 43lbs
To replace the injectors in 86 Toyota truck 22r, simply refer to your user and service manual.
Because it has Toyota stamped on it.