The length of the drive belt for a Ford LT 12 lawn mower is typically around 86 inches. However, it's always best to check the specific model's manual or consult a dealer for the exact specifications, as variations may exist. Additionally, ensure you verify the belt's width and type for proper fit.
the drive belt is 76 length 1.5 width
We will need some more details... Is it the drive belt or the belt for the blades?it is the drive belt for Murray lawn mower model 38618x92a
The belt from the mower engine to the transmission would be called a drive belt.
How do you replace a mower deck belt on a stx38 hydro
You have probably broken the drive belt. With the mower turned off, lie on the ground and look underneath the mower. There is a deck belt and a drive belt. The drive belt is the upper belt. Grab the upper belt and see if it is broken.
To change the drive belt on a Bosch Rotak 36 mower, first, ensure the mower is unplugged for safety. Remove the mower housing by unscrewing the necessary screws, and then carefully detach the old belt from the motor and drive pulley. Install the new belt by threading it around the pulleys, ensuring it is properly aligned, and then reassemble the mower housing securely. Finally, test the mower to ensure the new belt is functioning correctly.
To put on a drive belt on a lawnmower, first ensure the mower is turned off and disconnected from the power source. Remove the mower deck by loosening any bolts or clips that hold it in place. Next, locate the drive belt's path according to the mower’s manual, and thread the new belt through the appropriate pulleys and around the engine drive pulley. Finally, reassemble the mower deck, ensuring everything is secure before testing the mower.
It depends on the size of the drive pulley to the cutter pulley. The shorter the belt is the less slack is caused and therefore the more traction is maintained between the belt and pulleys
There is usually a deck belt and a drive belt.
Impossible to answer without knowing year, make & model, of mower.
Not an easy task. Never had to remove steering rods and break shaft set up to install a drive belt on a mower before.
To change the drive belt on a John Deere 260 lawn mower, first, ensure the mower is turned off and disconnected from the power source. Remove the mower deck by detaching any necessary bolts and pins, then locate and remove the old drive belt from the pulleys. Install the new belt by routing it according to the diagram usually found on the mower or in the owner's manual, ensuring it fits snugly on all pulleys. Finally, reattach the mower deck and double-check the belt alignment before testing the mower.