You can obtain a pilot assembly for a Martin gas heater model V5850MT from various sources. Check with local HVAC supply stores or Plumbing supply retailers, as they often carry replacement parts for gas heaters. Additionally, you can search online on websites like Amazon, eBay, or specific HVAC parts retailers. If you prefer direct assistance, contacting Martin's customer service or authorized dealers may also help you find the correct part.
On a Raypak heater, the pilot light is typically located near the burner assembly, usually at the bottom of the unit. It can be accessed by removing the front panel or cover of the heater. The pilot light is a small flame that ignites the main burner when the heater is activated. Always refer to the specific model's manual for precise instructions and safety information.
The water heater pilot can go out due to issues such as a faulty thermocouple, a dirty pilot light, or a lack of gas supply.
To turn on the water heater pilot, locate the pilot light button or knob on the water heater. Turn the knob to the "pilot" setting and hold it down. While holding the knob down, use a long lighter to ignite the pilot light. Once the pilot light is lit, continue holding the knob down for about a minute before releasing it. This should successfully turn on the water heater pilot.
To determine if the water heater pilot light is out, locate the pilot light access panel on the water heater. Look inside to see if the pilot light is lit. If it is not lit, you may need to relight it following the manufacturer's instructions.
High winds, pilot generator. Is the heater located next to a wall? Is the heater door closed? Does the heater have a draft hood or what they call a stackless heater? Ken
To light a gas heater with an electronic pilot, locate the pilot light button on the heater. Press and hold the button while simultaneously pressing the ignition button. Keep holding the pilot button for about 30 seconds to allow the pilot light to ignite. Release the pilot button and adjust the temperature as needed.
Have you turned the control from Pilot to On? Have you increased the temperature setting?
The pilot light on the water heater went out because there was a lack of gas flow or a problem with the ignition system.
To relight the water heater pilot, locate the pilot light button or knob on the water heater. Turn it to the "pilot" setting and hold it down. While holding the button down, use a long lighter to ignite the pilot light. Keep holding the button for about a minute after the pilot light is lit to ensure it stays on. If the pilot light continues to go out, there may be an issue with the thermocouple that needs to be addressed by a professional.
Thermocouple. Keep pilot knob depressed for 30 seconds after lighting pilot.
The pilot light on your water heater may have gone out due to a variety of reasons, such as a faulty thermocouple, a clogged pilot orifice, a gas supply issue, or a draft in the area where the water heater is located. It is important to troubleshoot and address the specific cause to safely relight the pilot light.
If the pilot light is on, the heater should come on by itself. If the pilot light is off then it has to be lit. If it will not stay on, the thermocouple is bad.