answersLogoWhite

0

To pull diagnostic codes from a 1985 BMW 528e, you need to locate the diagnostic connector, typically found under the driver's side dashboard. Use a jumper wire to connect pins 1 and 2 on this connector. Once connected, turn the ignition key to the "on" position without starting the engine, and the check engine light will blink to indicate the trouble codes. Count the blinks to determine the specific codes, which you can then reference in a repair manual or online resources for further diagnosis.

User Avatar

AnswerBot

1mo ago

What else can I help you with?

Related Questions

How do you check the Service Engine Light codes on a 1985 Buick Riviera?

engine light


What are the check engine codes for a 1985 Toyota 4runner?

There are hundreds of different codes that can cause the check engine light to come on. It needs to have a code reader hooked up to find out the specific code. Most auto parts stores will do this for free.


Why does loss of power light keep coming on when the car is cold on a 1985 Chrysler LeBaron?

That is the same as the check engine light. You will need to have the system checked for codes to know possible causes.


What would cause an engine surge and check engine light on a 1985 Pontiac Grand Am and how do you repair it?

There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.


What are the engine codes for a 1985 Chevy Celebrity?

The engine codes for gasoline engines in the 1985 Chevy Celebrity: 2.5L 4 cylinder engine code R 2.8L V6 mpfi code w 2.8L V6 carburettor code x


How do you know if the mass air flow meter is bad on a 1985 Jaguar XJ6?

To determine if the mass air flow meter (MAF) is bad on a 1985 Jaguar XJ6, first check for any diagnostic trouble codes using an OBD scanner, as a faulty MAF can trigger a check engine light. Additionally, inspect the MAF for any signs of physical damage, dirt, or corrosion. A drop in engine performance, poor fuel economy, or rough idling can also indicate a failing MAF. Finally, you can test its functionality with a multimeter to check for proper voltage output while the engine is running.


Why does your amps light stay on on a 1985 ford crown Victoria?

Check at the battery with a volt meter, Should have over 14 volts when engine is running. If not, possibly have to replace the alt. or check all the wires.


What would cause a rough idle after driving on a 1985 camaro V8 tuned-port fuel injection then check engine light comes on?

a plug misfiring would cause the rough idle and check engine light or if u changed the plugs and wires u could have put the plug wires in the wrong order


How do you reset the Check Engine light on a 1985 MR2?

First fix whatever the problem is. That alone oughta turn the light off. Otherwise, either disconnect the battery for a minute or so, or remove the 15A EFI fuse #12 in the engine compartment fuse box for a minute or so.


How do you turn off engine light on a 1985 bmw 528e?

To turn off the engine light on a 1985 BMW 528e, you can start by checking for any trouble codes using a diagnostic tool or by jumping the diagnostic connector. If you identify and fix the underlying issue, the light should turn off automatically after a few driving cycles. Additionally, you can disconnect the battery for a few minutes to reset the system, but this won't address any underlying problems. Always ensure that any issues are resolved to prevent the light from reappearing.


How Reset check timing belt light 1985?

With a scan tool or by unhooking the battery.


How do you check transmission fluid BMW 1985 635csi?

the dipstick is near the back of the engine compartment. Check while at running temp