To check the fluid in a 1963 Corvair Monza 90 standard transmission, start by locating the transmission fill plug, typically found on the side of the transmission case. With the vehicle on a level surface, remove the fill plug and check the fluid level; it should be just below the edge of the fill hole. If necessary, add the appropriate type of Transmission Fluid until it reaches the correct level. Always ensure the transmission fluid is clean and free from contamination.
A standard or manual transmission, doesn't use transmission fluid.
through the fill plug on the drivers side of the transmission
if it is an automatic then yes, if it is a standard transmission then no
To stop a standard transmission from grinding into third gear, check the level of the transmission fluid. If the noise continues, consult a mechanic.
== ==
go on bing.com
dip stick
Should be a plug at the side of the transmission fill to this level
Looking from under the car, there is a check plug on the transmission. Have to remove the plug, the oil should just drip out, if not, add to the level of the plug only.
it depends if it is an automatic or standard the automatic has a dip stick under the hood and a standard has a plug on the drivers side of the transmission.
Mitsubishi gallant is both automatic and standard. You can check out some car classifieds on the net to see the different transmission.
Under the car on the upper side of the transmission you will find a plug. Remove the plug and stick you finger in the hole. If you feel fluid, then it is full.