answersLogoWhite

0

Linning up the clutch assembly so the pilot shaft slides in easily. If the pilot shaft does not slide in easily, start over, do not force it together by drawing the transmission in with the attachment bolts.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you know when your clutch is bad?

There are various ways through which you can know when your clutch is bad. When you are having troubles shifting gears, this might be a clear indication of a clutch problems.


What is another name for a pressure plate assembly?

Clutch cover


Remove clutch assembly from 250 polaris trailblazer picture?

A picture of the clutch assembly removal process for a 250 Polaris Trailblazer can be found in the repair manual. It details how to access, disassemble, and remove the assembly.


How can you change out an automatic and put in a manual tranny for a 76 camaro?

You will need a flywheel assembly, Clutch assembly, Through out bearing assembly, Bell housing and Clutch peddle assembly. A lot of hard work. Why just not beef up the automatic that's in it?


Why does the clutch pedal on a 1998 cavalier not spring back?

the return spring on the clutch pedal assembly must be replaced.


Where is the bell housing to disengage the clutch?

The bell housing surrounds the clutch assembly. Mounted between the engine and the transmission.


Remove clutch pedal 2004 GMC sierra?

how to remove a clutch pedal assembly 2004 gmc sierra


How do you replace the air conditioning clutch assembly on a 2000 dodge caravan 3.0 V6?

There is a special tool that will pull the clutch assembly off of the compressor, available at your local parts store!


What is the screeching sound when you press the clutch on a 97 Montero Sport?

Your throw-out bearing has went bad in the clutch assembly. You will have to replace the bearing. Inquire about a throw-out bearing at your local auto-parts store. It is a good rule of thumb that if you're going to dissasemble the clutch assembly, you should replace the clutch, and pressure plate too! When clutch-assy has been removed, check the fly-wheel for scarring on its face where the clutch assembly was once attached. The face should be smooth, and the fly-wheel should NOT be warped, pitted, or damaged! If it is, replace it before you put a brand new clutch assembly back onto the vehicle. FabianTrahan Shadetree-Mech


What are all of the components in a standard GM small block clutch assembly?

clutch plate,pressure plate,throwout bearing


What is the part called that holds the clutch fan ON a 98 s10 2.2?

That would be a clutch fan hub and bearing assembly.


Is the clutch on a 1996 dodge neon hydraulic?

No. The clutch is cable-actuated from the pedal assembly to the throw-out/release bearing fork asembly. There is no hydraulic assist in the clutch system.