answersLogoWhite

0


Best Answer

Depends on the column.....

For a regular C18, try running 10% methanol through and then full-loop injections of 50% DMSO repeatedly until you're happy with the result. Also, reduce the run-time. For me, 3 minutes for a 2x50mm.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How much dmso should be used for a c-18 hplc column to knock out everything retained in the column?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the knock in the steering column in your 2004 Chevy Tahoe?

They had a problem with the steering column shaft slip joint, it was too sloppy. They have a replacement part to cure that problem available at the dealer.


What does code P0328 mean for a 2002 Subaru Forester?

P0328 on an OBD11 equipped automobile (everything since 1996) is a knock sensor code. I believe that it says the reading is over the high limit. You should focus on the knock sensor and the wiring leading to it. --Ken


What sport can you lose teeth?

EVERYTHING!!!!! Even tea parties can knock ur teath out


Can you run the car with a knock sensor?

Yes, you should always run your vehicle with its Knock sensor.


What should you do for coughing?

knock ur back


How do you beat level 14 on 40x escape?

Click on the door 3 times (knock knock knock).


Will it hurt engine to drive with bad knock sensor?

Yes it can hurt your engine to drive with a bad knock sensor. The knock sensor should be replaced as soon as possible.


What is the knock hill radio station?

it is a glitch in the system... it should not be there


Which instrument should be used to test for combustion knock?

opacimeter


Should the knock sensor fit in a certain position?

yes


What is the secret knock of the sleepover club?

The secret knock is knock knock, knock knock knock knock


Why does your 93 Cadillac DeVille knock when the engine is accelerating?

If it is more of a ping than a knock then just try running some higher octane fuel in it. If is more of a knock it could be a rod or crankshaft bearing. If it is definitely a knock you should get it looked at right away.