The brake light over the trunk is commonly referred to as the "third brake light" or "high-mounted stop lamp" (HMSL). It is designed to enhance visibility and alert drivers behind the vehicle when the brakes are applied. This light is typically mounted higher than the main brake lights, improving its visibility in various driving conditions.
there are plastic covers over them on the inside of the trunk that you pop off
open trunk remove carpet over taillight remove retaning screws
you open up your trunk and thir are 3 knobs behind the light, then take those out then you could pull the tail light out and put your new one in then do the reverse process over again
To replace the center brake light in a 2002 Ford Thunderbird, first, open the trunk and locate the plastic cover over the brake light assembly. Remove the cover by unscrewing any screws or unclipping it. Next, twist the bulb socket counterclockwise to release it, then pull out the old bulb and replace it with a new one. Reassemble the socket, replace the cover, and test the brake light to ensure it works properly.
If the trunk lid isn't actually ajar, the switch has gone out of alignment, or it broke.
Its called "covering"
Faulty or over sensitive parking brake switch or sensor.,
Your brake fluid level is low.
Look in the trunk, there is a cover over the light assembly - open and you will have access to change the light.
Well, honey, changing a brake light bulb on a Mitsubishi Galant is as easy as pie. Just pop open the trunk, locate the back of the light assembly, twist out the old bulb, pop in the new one, and voila! You'll be lighting up the road like a Christmas tree in no time. Just remember to test it out before you hit the road, unless you're into getting pulled over by the fashion police.
check brake lite switch under dash check power toit if so power out (orange and white )if good go to trunk driver side look for rear wiring harness over time wires become brittle and crack this is where the open will be
To change the trunk light in a 2002 Nissan Maxima, a person will need to unscrew the cover over the light. Then they can remove the old bulb and replace with a new one. Then screw the lens cover back on.