If your Z400 won't move when you put it in gear, it could be due to a few reasons. First, ensure the clutch is fully disengaging; a malfunctioning clutch can prevent the bike from moving. Additionally, check if the kickstand is down, as many bikes have a safety feature that prevents them from moving in gear with the stand engaged. Lastly, inspect the transmission for any mechanical issues or low oil levels that could affect performance.
Your clutch is slipping.
transmission problem
stock to stock my buddy has a z400 and i have a 400ex and me and him are the same weight and we are side by side the hole time and they both will go about 70mph it depends how much weight you put on the quads
I have a 95 Lumina 3.1 and it would cut out of gear when I would stop, it turned out to be the sprag gear in the transmission. $$$$
replace or rebuild the carburetor
When you put it in gear, does it pop out? What gears? If so, you probably have a bad transmission. It the clutch is slipping, you need to adjust the clutch cable.
it is probably something as simple as adjusting the carb
Check the fuel pump and fuel filter.
well i dont realy know how but i tried and my Phillips go-gear mp3 player wont support it so idk
You can also start a car in Neutral. Also remember to put your foot on the brake too.
Pot and pan racks are usually found above the stove or the kitchen sinks. Put them anywhere that is convieniant to you and where they wont get in the way.
could be the neutral safety switch.