Yes. Do not exceed 100 meters in length.
Run them both together using lan cables into the router.
what i do is google picnic and then click it and from there it would or should tell u what to do! what i do is google picnic and then click it and from there it would or should tell u what to do!
A UTP coupler is a small block to which you can connect two UTP cables to form a longer one. Handy if you have 2 short cables but need a long one.
Easy Setup:Connect 2 Computers Directly Using Crossover Cablehttp://www.home-network-help.com/crossover.HTMLyou will need a crossover cable to do this. pairs are switched allowing communication to occur without a hub or routerTAKE THE CAT5E CABLE AND TWO JACKS.YOU WILL FIND 4 PAIRS OF WIRES. LIKE OW-O,BLUEW-BLUE,GREENW-GREEN,BROWNW-BROWN. IN THIS THERE ONLY FOUR WIRES ARE NEEDED. supoose you have crimped one side like this ow-o-gw-g-blw-bl-brw-br.then other end will be gw-bl-ow-bl-o-brw-br.ow-orange white o-orange blw-blue white bl-blue grw-green white gr-green brw-brown white br-brown COLUR CODE : 1----3 2----6 3----1 4----4 5----5 6----2 7----7 8----8AndBoth computers need to have a NIC(Network Interface Card) installed.The computers need to have different IP addresses in the same IP subnet. This gets set in Network Properties - TCP/IP Properties. Easiest would be to set one at 10.0.0.1 and the other at 10.0.0.2, both with a netmask of 255.255.255.0SOMTIMESA NIC will have the crossover setting in the device driver
1. It keeps cables out of the way of moving parts (such as drive bays) so they cannot get snagged. 2. It stops the cables moving - preventing short circuits if a cable is worn. 3. It keeps cables away from thermal hotspots such as the CPU or GPU heatsink, which can reach very high temperatures, making the cable isolation brittle 4. It keeps cables from blocking the airflow, required to reach the heatsinks and hard drives. (This also helps keeping the noise down.)
You do not need specific cables for the PS2's Ethernet jack. Ethernet is standardized; any CAT5 cable will work fine for use on a PlayStation 2.
I'd like to answer your question. Could you please clarify: 1. Are you talking about CAT5 (network) cables? 2. RS232 cables? 3. {Insert hardware here}?
A Cat5 cable contains 4 pairs of 2 wires twisted together, making a total of 8 individual wires, however only 2 wire pairs (4 wires) are actually used for communication.
Cat 5 straight cables conections are straight e.g. 1 - 1, 2 - 2 etc With crossover cables wires its wired like so: 1 - 3 2 - 6 3 - 1 4 - 4 5 - 5 6 - 2 7 - 7 8 - 8
A compound.
When 2 or more thunderstorms join together.
A protein.
polymerization
You would use cross-wired cables to connect 2 computers together.
you cant "join" Pokemon, but you can make babies with two Pokemon
0
yes