transparent
A five-minute update timer has elapsed.
There isn't one. The switch only knows about MAC addresses, and the default gateway isn't one of those addresses.
to determine which ports are not correctly configured to prevent MAC address flooding
This feature is named "port mirror" or SPAN. You need to get a manageable switch to have this feature. You also need to setup a passive monitoring program(ie: WFilter) to monitor the traffic.
Store-and-forward switching is a method used in networking where a switch receives the entire data packet before forwarding it to the appropriate destination. This approach allows the switch to check for errors and determine the best path for the packet, enhancing reliability and efficiency. However, it can introduce latency since the switch must wait to receive the complete packet before making forwarding decisions. Additionally, this method contrasts with cut-through switching, which begins forwarding the packet as soon as the destination address is read.
Stp and vsrp
A hostname
Switch ports Fa0/1 and Fa0/3 are configured to carry data from multiple VLANs.
Diode is a two terminal semicon. Diode is a Switching device
In a residential electrical system, 1-way switch wiring is typically configured with a single switch controlling a single light or electrical fixture. The switch has two terminals for the live wire and is connected to the fixture with a single cable. When the switch is flipped, it either completes or breaks the circuit, turning the light on or off.
VTP transparent mode allows a switch to forward VTP advertisements but does not participate in the VTP domain. This mode is useful when you want to maintain VLAN information locally without affecting the rest of the VTP domain.
A five-minute update timer has elapsed.
no.
switch(config)#int type <no> switch(config-if)#switchport mode trunk switch(config-if)#switchport trunk allowed vlan all/vlan no switch(config-if)#exit switch(config)#exit switch#
In cut through switch received data is directly forwarded to the destination & in the store and forward switch received data is stored in the switch for future use and then forwarded to the destination.
For VLAN Trunking Protocol (VTP) to function correctly, all switches in the VTP domain must be configured with the same VTP domain name. Additionally, at least one switch must be set to VTP server mode to create and propagate VLAN information, while other switches can be configured as clients or transparent modes. Proper trunking must also be established on the links connecting the switches to facilitate the transmission of VTP advertisements.
It is configured in VTP server mode. STP is automatically enabled. All switch ports are assigned to VLAN1.