To check OBD-I codes on a 1992 Mitsubishi Montero, locate the diagnostic connector under the dashboard, typically near the driver's side. Use a jumper wire to connect pins 1 and 2 of the connector. After doing this, turn the ignition key to the "On" position (without starting the engine), and the check engine light will blink to indicate the trouble codes. Count the blinks to decipher the codes, which can then be referenced in a repair manual for troubleshooting.
Could be a restricted exhaust such as a damaged catalytic converter. Could also be a problem with fuel delivery. If you have a check engine light illuminated, check for codes.
HeyKen==You need to repair what turned it on in the first place then have auto zone remove the trouble codes. GoodluckJoe
disconnect the battery for a couple of minutes, if it comes back on after you drive the computer is getting an error code from the engine check the codes to see whats causing it
you have to go to a autoparts that check and see what codes come up
You may think there is nothing wrong but there is. If the check engine light is on there will be codes stored in the ECM. Have the codes read. The codes will help you determine what the cause is.
it's under the glove box [behind] to the far right [blue].
To check trouble codes on a 1995 Chevy Beretta, first, locate the diagnostic connector under the dashboard near the steering column. Use a paperclip or jumper wire to connect terminals A and B on the connector. Turn the ignition key to the "On" position without starting the engine, and the check engine light will begin to flash, indicating the trouble codes. Count the flashes to determine the corresponding codes, which can then be referenced to diagnose any issues.
To check the trouble codes on a 1989 Dodge Colt, you need to locate the diagnostic connector, which is typically found under the dashboard near the steering column. Use a jumper wire to connect terminals A and B on the connector. Turn the ignition key to the "On" position without starting the engine, and the check engine light will begin to flash, indicating the trouble codes. Count the flashes to interpret the codes as per the vehicle’s service manual.
check your exhaust it could be you cadilidic converter Have someone read the codes that are set. The codes will help lead you to the problem.
You might have the codes located in your owners manual. If you dont, then try calling Mitsubishi and ask them for codes or where you might find them. I know when I take the battery out of mine the radio requires a code and you only get three tries to put them in otherwise you have to take the battery out then put it in again. Hope this helps. Patrick
To read the trouble codes in a 1993 Ford Topaz, you need to locate the diagnostic connector, usually found under the dashboard near the driver's side. Once you find the connector, you can use a code reader or jumper wire to extract the trouble codes, which will flash on the check engine light. Refer to a repair manual specific to your vehicle to interpret the codes.
There are dozens of things that turn the light on. Get the codes read at the auto zone.