answersLogoWhite

0

DOCSIS 2.0 cable modems primarily support IPv4, but they can be upgraded to support IPv6 through firmware updates and network adjustments. Operators can implement IPv6 alongside IPv4 using techniques like dual-stack, where both protocols run simultaneously. However, full IPv6 support is typically more robust in DOCSIS 3.0 and later versions, which are designed with enhanced capabilities for modern internet requirements. Ultimately, while some level of IPv6 support may be achieved with DOCSIS 2.0, transitioning to newer standards is recommended for optimal performance.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

Does IPv6 work on Linux?

Yes. The Linux kernel has supported the IPv6 protocol since 1996.


Which version ios support ipv6?

IPv6 support was first supported in IOS version 12.2T, which was the beta version of 12.3. You need to install the Advanced IP Services to get IPv6.


What four routed protocols are supported by EIGRP?

Off the top of my head it is IPv4 IPv6 Appletalk IPX


What are the uses of ipv6 for commercial?

what is the commercial use of ipv6?


What is the length in bits of a logical IP address IPv4 and IPv6?

32 bits (for IPv4), or 128 bits (for IPv6).32 bits (for IPv4), or 128 bits (for IPv6).32 bits (for IPv4), or 128 bits (for IPv6).32 bits (for IPv4), or 128 bits (for IPv6).


Does Windows XP support IPv6?

Short answer - yes.You need to be running Service Pack 1 at a minimum.Service Pack 2 has an even more complete IPv6 stack.To enable IPv6 on XP, open a command prompt window and type:C:\> ipv6 /?Did you then see this result?:C:\> ipv6 /?Could not access IPv6 protocol stack - the stack is not installed.To install, please use 'ipv6 install'.If you did get the above result, simply type:C:\> ipv6 installIt will take a few seconds, and then your Windows XP system will be fully IPv6 enabled.


When a Cisco router is being moved from an IPv4 network to a complete IPv6 environment which series of commands would correctly enable IPv6 forwarding and interface addressing?

To enable IPv6 forwarding and configure interface addressing on a Cisco router moving to an IPv6 environment, you would first enter global configuration mode and enable IPv6 routing with the command ipv6 unicast-routing. Next, you would access the specific interface using interface <interface-name> and assign an IPv6 address with the command ipv6 address <ipv6-address>/<prefix-length>. Finally, use the command no shutdown to activate the interface.


Why is ipv6 not available?

IPV6 is relatively new and doesn't work everywhere yet.


How many bits are used for an IP address in IPv6?

IN IPv6 we can find 128bits.


How many bits are in an IPv6?

IPv6 uses a 128-bit address space


What can you use to identify a ipv6 address?

IPv6 address has 2^128 address and IPv6 address is of 16 bytes and is represented in colon hex notation.


How do you have the tunnel interface and the IPv6 Loopback interface as the only connections running IPv6?

by unchecking the check box of IPv6 in local area network properties