answersLogoWhite

0

What else can I help you with?

Related Questions

When a Cisco router is being moved from an IPv4 network to a complete IPv6 environment which series of commands would correctly enable IPv6 forwarding and interface addressing?

To enable IPv6 forwarding and configure interface addressing on a Cisco router moving to an IPv6 environment, you would first enter global configuration mode and enable IPv6 routing with the command ipv6 unicast-routing. Next, you would access the specific interface using interface <interface-name> and assign an IPv6 address with the command ipv6 address <ipv6-address>/<prefix-length>. Finally, use the command no shutdown to activate the interface.


What does the passive-interface command do?

Passive-interface command is used in all routing protocols to disable sending updates out from a specific interface.


What is 3 differences between software interface and command line interface?

Differentiate between Command line interface and Menus interface and example of each interaction style


What interface is an interface that uses graphics as compared to a command-driven interface?

Graphical User Interface


What is a command line interface and graphical user interface?

Xyte/185.1838xyte


Vocabulary of a command line interface?

Go to command prompt and run "help" command..


What command activates an interface?

no shutdown


What is cui mode?

command user interface & graphic user interface


What interface allows remote management of a Layer 2 switch?

The interface that allows remote management of a Layer 2 switch is typically the Command Line Interface (CLI) accessed via a secure protocol like SSH (Secure Shell) or Telnet. Additionally, many Layer 2 switches also offer a web-based graphical user interface (GUI) for management, enabling network administrators to configure settings and monitor performance remotely. These interfaces facilitate tasks such as VLAN configuration, port management, and troubleshooting.


What is the acronym of CLI?

Caller Line Identification, also known as caller ID.


What does the enable command do in a cisco router?

The "enable" command will bring the privilege level from user exec to privileged exec. Example: R1> R1>enable R1#


Which command can be used at the command line to start the Network Configuration program?

To start the Network Configuration program from the command line, you can use the command nmtui for a text-based interface or nm-connection-editor for a graphical interface, depending on your system configuration. Alternatively, on some systems, you might use network-manager or nmcli for command-line management of network connections. Make sure to run these commands with appropriate permissions if required.