0
What else can I help you with?
What is the minimum configuration for a router interface that is participating in IPv6 routing?
link-local address
When would you configur a GRE tunnel?
To configure a GRE tunnel, create a tunnel interface by issuing the interface tunnel command from the global configuration mode. To configure the tunnel source and destination, issue the tunnel source {ip-address | interface-type} andtunnel destination {host-name | ip-address} commands under the interface configuration mode for the tunnel.
What is the advantage of configuring a static route with an exit interface instead of a next-hop address?
The exit interface configuration consumes less router processing time
What is the advantage of configuring a static route with an exit interface instead of next hop address?
The exit interface configuration consumes less router processing time.
Which interface requires an ip address to transport ios or configuration files from the router to a tftp server on the lan?
Ethernet
What will happen if an interface IP address is entered for the address portion of the network command in a RIPv1 configuration instead of a network address?
All interfaces in the same classful network as the configured address will be included in the RIPv1 routing process.
How do you setup a dynamic IP address?
Just set the computer's IP Configuration settings to dynamic. That's it. Dynamic means that the IP Address is obtained automatically from a DHCP server.
Which two components are used to determine the router ID in the configuration of the OSPF routing process?
the highest IP address of any logical interfacethe highest IP address of any physical interface
What is global router configuration?
I'll go to hellis Cisco in a Cisco router. What would the prompt look like for global configuration
Why does the switch between Host and the router not require configuration with an IP address to forward packets?
If a switch is connected to a router then the MAC address of the router is known to the switch through that port. A host takes advantage of this by using the default gateway address (the address of the router) which the switch "knows" by its lookup table. Therefore, the switch can learn the address automatically and no configuration is necessary.
What protocol automatically configures IP configuration for a client?
The protocol that automatically configures IP settings for a client is called Dynamic Host Configuration Protocol (DHCP). DHCP allows devices on a network to receive IP addresses and other network configuration parameters automatically, eliminating the need for manual configuration. When a client connects to the network, it sends a request to the DHCP server, which then assigns an available IP address and provides additional information like the subnet mask, default gateway, and DNS servers.
If there is no DHCP server to provide a computer a unique IP address how is a computer able to acquire an IP address?
If there is no DHCP server available, a computer can acquire an IP address through a process called Automatic Private IP Addressing (APIPA). In this scenario, the computer automatically assigns itself an IP address from the reserved APIPA range (169.254.0.1 to 169.254.255.254) if it cannot find a DHCP server. This allows the device to communicate with other devices on the same local network that also use APIPA. However, it won't be able to connect to external networks without a proper DHCP server or static IP address configuration.
