0
What else can I help you with?
A network technician wants to configure an IP address on a router interface by using the ip address 192.168.1.0 255.255.255.0 command Which prompt should the technician see when entering this comman?
router(config-if)#
Starting at the enable mode prompt what commands would you type to configure IP address 192.168.1.1 on interface E0?
I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#
What is global router configuration?
I'll go to hellis Cisco in a Cisco router. What would the prompt look like for global configuration
Which fields of the IPv4 header change from router to router and why they change?
IP address remains the same. Mac address changes from router to router.
Which command turns on a router interface?
While in the interface mode your prompt should look like this:RouterName(config-if)#Then type the command:RouterName(config-if)# no shutdown
When a router does not have an interface for the destination network it sends the traffic to where?
If a router has a route in its routing table, it will have a next hop IP address and / or outbound interface. If a router does not have a route in its routing table the packet will be dropped.
What is the effect of issuing the hostname RouterA command on a router?
A description will be configured on the router interfaces identifying them as belonging to RouterA.The router will attempt to establish a connection to the host with the name RouterA.The router will map an IP address to the domain name RouterA.The router prompt will change from Router(config)# to RouterA(config)#
To which network device or interface does the IP address 192.168.1.254 belong?
That is normally the IP address of a router
Which command when issued in the interface configuration mode of a router enables the interface to acquire an IPv4 address automatically from an ISP when that link to the ISP is enabled?
In the interface configuration mode of a router, the command ip address dhcp enables the interface to acquire an IPv4 address automatically from an ISP via DHCP when the link to the ISP is enabled. This command instructs the router to request an IP address and other configuration information from a DHCP server. After issuing this command, ensure that the interface is also enabled with the no shutdown command.
What mode must be in to configure IP address on a Cisco router?
interface mode
What address should be pinged from this host to confirm that the router interface is operational?
Default Gateway
What is the purpose of FastEthernet interface?
Connects the router to a single broadcast address. e.g. LAN
