u can do 40 with a pw80
With a Flat head Screwdriver
A vacuum gauge is all you need to tune in a carb. A gauge for each carb if you have more than one.
how to set Yamaha pw80 carburetor
yes they are all the same
replace the plug, clean dirt from carb, change the air filter,
well a pw80 goes 74kph and a kx65 goes 110kph
Because the carb is flooding - starting fluid (ether) dries up the piston and lets it fire - too much ether can damage your piston because it can strip it right dry
Yes there is.The pre 89 i believe had no limiter in the ignition system. Exhaust and Carb restirict. too. Heat up exhaust and remove restrictive washer. 2 get older ignition from pre 89 pw, overhaul carb. Buy a manual well worth the headache
Dry the motor out ! clean the carb and drain all oil ! If it wasnt run it should be ok ! just flush all liquid out properly and replace with new oil petrol etc !
It all depends on condition, if its a nice clean pw80 about 800-1200. hope this helped
All Yamaha PW80 s have 3 semi automatic gears ( no clutch lever etc )