Devide the wattage by the voltage
Ohm's Law - V = IR.
To calculate the capacity in megawatts of a 400 kV power line, you need to consider the current carrying capacity of the line. This is typically based on factors such as conductor size, ambient temperature, and the type of insulation used. Once you have the current carrying capacity, you can use the formula P = V x I to calculate the power capacity in megawatts, where P is power in MW, V is voltage in kV (400 kV in this case), and I is current in amperes.
The general equation for power in a BALANCED three-phase load is as follows:P = EL IL x power factor...where EL and IL are the line voltage and line current, respectively.So all you have to do is to manipulate the equation to make the line current the subject, and insert your figures.
To calculate current passing through a light globe, you can use Ohm's Law: current (I) = voltage (V) / resistance (R). To calculate voltage across a light globe, you can rearrange Ohm's Law to solve for voltage: voltage (V) = current (I) * resistance (R). Just make sure you know the resistance of the light globe in ohms.
If you go to the end of the current line and type J it will join the next line to the current.
A phase current is the current passing through a phase, whereas a line current is the current flowing through a line.
How do you calculate the production line personnel required?
In a balanced 3-phase system, if the three loads are star connected, the line current is equal to the load current. If the loads are delta connected, the line current is less than the load current by a factor of 1/sqrt(3).
To calculate the DG set current, you need the load current and the load voltage. To convert it into kilowatts it is divided by 1000.
Add them upAnswerThere is no 'total' current in a three-phase system. The current flowing in each line (not 'phase') is considered separately. And you most definitely don't 'add them up'!
It is current assests minus current liabilites
To calculate the DG set current, you need the load current and the load voltage. To convert it into kilowatts it is divided by 1000.