45353415343
434
413
By putting a diagonal arrow through the symbol.
An input force is what force you act upon a machine. The output is what it does for you in return.
The conversion gain, G, is one of the standard values usually measured and quoted to indicate the performance of a heterodyne or superheterodyne receiver system. G is called a 'gain' because it is a ratio of an output power to an input power. In most practical cases the actual output power is smaller than the input, so it would be more honest to call it a loss Despite this, the convention is to call it a gain, even if it is a gain of -10dB's, the output is ten times smaller than the input. It is called a 'conversion' gain because it indicates the relative level of an output which has been converted to a frequency which differs from that of the input.
When the component has positive and negative output (legs) such as LEDs
It carries a current at the set voltage of the line. Current is the actual electricity that flows along the line and is used up in your electric appliances whereas voltage is the difference between the energy being generated at the station and ground.AnswerIt carries both voltage and current. Voltage exists between each line conductor, and current flows through each line conductor.
The output stage.
how does input device work
"Vout" typically refers to the output voltage of a circuit or device. It is the voltage level that is generated or present at the output terminal or node of the circuit. Voltage output is a common measurement parameter in electronics and electrical engineering.
a Block Diagram usually means that you draw the main components of a circuit/system with boxes *pretend / means in a box -/amplifier/-->/Analog to Digital Convertor/-->/Output/ a Block Diagram usually means that you draw the main components of a circuit/system with boxes *pretend / means in a box -/amplifier/-->/Analog to Digital Convertor/-->/Output/
UPS is Uninterruptable Power Supply. It is neither input not output. It supplies electrical power to a computer when the main electrical supply is interrupted. It does not handle data in any way.
Circuit breakers do not have circuit diagrams. The breakers have an input where the distribution voltage is applied and an output where the load is applied. If you want to know what is inside a breaker, the electrical terminology to use is "shop drawings" of the specific breaker that you need information on.
A microphone is a device with an electrical output. An acoustic wave is the input. Its only function is to 'capture' sounds and convert them into an electrical signal for processing by the computer.
The data goes to the printer so it is an output device.
Automatic garage door opener with a remote The answer above will give a mechanical output not an electrical output. Photocells come to mind.
You must mean output relay interface. Essentially, it's a circuit board with one or more relays used for switching electrical loads by another device such as a computer or programmable controller.
the voltage selector circuit is used for converting input electrical energy through the voltage selection circuit,which is arranged within the transformer body with its two ends electric allay connected to an input port and an output voltage connection device must be plugged in a socket portion on the transformer body to initalize a micro control unit through feedback to change a volatage value sent to a voltage transformer unit and in turn change the voltage of output electrical energy until a display device displays an ideal output voltage value. Then, the user removes the connection device, and the voltage value of the input electrical energy is converted into corresponding to the selected
A surge protector is neither an input nor output device. It is an appliance designed to protect electrical devices from voltage spikes.
A surge protector is neither an input nor output device. It is an appliance designed to protect electrical devices from voltage spikes.