Yes the amp can push the 2 subs. I have 2 1250 watt 12inch subs and 1 maybe 400 or 500 watt amp and the amp does fine but if you want more bass at lower levels of volume then you want to have a bigger amp. Just make sure your amp doesnt blow your subs.
get the 2800
yeah it is i had 2 12s and 2 10s hooked up to a 900 watt amp and it hit hard
It depends on the specific power-handling capabilities of the subwoofers and their impedance. If the subwoofers have a total power handling capacity that is lower than 300 watts and the amplifier can provide enough power at the required impedance, then it should be able to adequately power the two tens. However, if the subwoofers have a higher power handling capacity or the amplifier cannot provide enough power, it may not be sufficient.
To power your 3200 watt subwoofers effectively, you should look for an amplifier that can deliver at least 3200 watts RMS (Root Mean Square) power output at the impedance (ohms) of your subwoofers. It's important to match the impedance of your subwoofers with the amplifier to ensure optimal performance. Additionally, consider factors like amplifier efficiency, distortion levels, and compatibility with your audio setup when selecting the amplifier.
A Rockford 250 watt amp would compliment a 12" Subwoofer very nicely.
Depends on the size of the amplifier you are installing and the power required to run it. You can easily install a 500 watt amp with no problems.
Yes, a Planet Audio 800-watt amplifier can push a 12-inch 1300-watt Pioneer subwoofer or a 12-inch 1200-watt Sony Xplod subwoofer, but it may not fully utilize their maximum potential. The amp's power rating indicates its ability to deliver sound, but the subwoofers can handle more wattage, which means they may not reach their fullest performance. It's important to ensure that the subwoofer's impedance matches the amplifier's output for optimal sound quality and efficiency.
This is determined by how you wire your subs to your amp. If you get an amp that's bridgeable to mono, then you can wire your subs in series. You will get much more thump if you do it this way. However, make certain that your amp is bridgeable, and stable down to 2 or even 1 Ohms. Check with the dealer you buy from. When wired the way I mentioned, a 300-Watt amp will probably do nicely!
Find out what the rms is for that sub woofer,if it'1000 then find out what the max is,then you could go between the rms power and the max power to get the right amount of watts.
Yes
Yes, you can use a 30-watt speaker with a 60-watt amplifier. The amplifier's higher wattage provides more power than the speaker is rated for, but as long as you don’t push the amplifier to its maximum output, the setup can work without damaging the speaker. However, it’s important to avoid excessive volume levels, as this could potentially lead to speaker distortion or damage. Always ensure to match volume levels appropriately to protect the speaker.
No thanks...I got a nice 4000 watt system.