(coded value - measured value) /coded value x 100
'Force' isn't measured in volts. Potential and potential difference are measured in volts.
From what I can remember it's: |R(measured)-R(real)|/(R(real))*100%
Resistor is a current a insulator is a not conductive and conductors can conduct.
There is no relation between the resistor's ohms value and its size. The power of the resistor can be seen by its size. If the power is too small, the resistor can be destroyed.
A resistor is a device designed to detect difference in current and stop the flow of electricity. On most every type of electric engine or circuit has a resistor.
The voltage across the resistor at the instant in the circuit where Vab is measured is equal to the potential difference between points A and B.
The difference between a variable resistor and a rheostat is the same as the difference between six and half a dozen.
Difference between thick and thin film resistor is not related to thickness but its based on how the film is applied to the surface.
dpr8ea9 is a resistor plug dp8ean is non resistor.
A non-ohmic resistor doesn't have a constant resistance. A ohmic resistor has a constant resistance.
The phase difference between the current through the resistor and inductor in an AC circuit is 90 degrees.
its the colour of the fixed and the variable we define it by its power and name
the R stands for Resistor. It is a resistor plug.
'Force' isn't measured in volts. Potential and potential difference are measured in volts.
Resistor is a separate unit from the blower motor
Variable resistors means that a resistor which can change its resistance by control by any person or it self and fixed resistor means that it can not change its value.
Where you are measuring. A simple filter will be two elements - a capacitor or inductor and a resistor. A capacitor will tend to "trap" low frequencies. In the case of a lowpass filter made of a capacitor and resistor, the output voltage will be measured across the capacitor. Inductors are the opposite, so the output would be across the resistor.