No
All AC voltages and currents are expressed as rms values, unless otherwise specified. So 120 V AC is an rms value.
In parallel circuit the current through the resistors are different in values depending upon the values of resistors. But the sum of the currents across all the resistors will be equal to the current through the sourcgsvg bdjasuhafyuhda
...what readings? current? voltage? power? lux?
when transmission we usually use high voltages becoz at higher voltages current is less(p=vi,voltage is inversly proportional to current at constant power) so that we can minimize copper losses i2R losses.
Both. When an AC voltage is measured and a number is reported, it is necessary to state that this number is rms value or peak value or peak to peak value.AnswerVoltages and currents are each normally expressed in root-mean-square (rms), unless otherwise stated. For example, when we talk about a '120-V service' or a '240-V service', we are expressing the voltages in rms values; it is unecessary to specify that these are rms values. For a sinusoidal waveform, Vrms = 0.707 Vpeak
mostly, how good your theory is. Remember, experimental values are from reality.
Absolutely not. Experimental is practical and theoretically anything is possible.
You'll find her G spot someday son
% error = |experimental value - theoretical value|/theoretical value * 100% It is the absolute value of the differe nce betwee n the experime ntal a nd theoretical values divided by the theoretical value multiplied by 100%.
yes, it is the best tested theory there is. Theoretical and Experimental values agree to about 9 digits of accuracy.
Direction only. If you reverse the connections to your voltmeter or ammeter you get the same size readings but the directions are indicated to be the opposite way around, by reversal of sign.
A yield is received after a person does the experiment. Second, they can never be same values. We can only get close to theoretical yield but never attain similar values under normal experimental conditions.
Quantum theory has been tested and theoretical and experimental values have been found to agree to more digits of precision than in any other theory tested against reality!
220 V is rms in europe if that is what you are getting at. Peak is at about 311 V.AnswerUnless otherwise stated, all a.c. voltages and currents are expressed in r.m.s. values.
In three-phase systems, we always consider individualline or phase currents, or individual line or phase voltages. In other words, we treat currents and voltages no differently from single-phase currents or voltages (i.e. we don't 'combine' them because they are three-phase quantities). So these quantities are expressed in r.m.s. values.
Correct characterization of matter chemical properties is possible by experimental studies; but theoretical methods exist for the approximate calculation the values for some chemical and physical properties.
These are the experimental values.