First and foremost is the information the manufacturer puts on the nameplate of the motor. Second, the generic amperage can be found on motor charts that are on the internet. Third you can use a formula to find the approximate amperage. HP = Amps x Volts x 1.73 x pf/746. Transposed for Amperage, Amps = HP x 746/Volts x 1.73 x pf. Use pf = .9 Amps = 10 x 746/ 208 x 1.73 x .9 = 7460/323.85 = 23.03 amps. See how much easier it is to read the nameplate.
The amperage of a motor is governed by the voltage that the motor operates on. Without a voltage given, an answer can not be given.
Watts = Volts times Amps. Therefore, if the voltage was 220 volts, the motor would draw 500 amps. If the voltage was 4,000 volts, the motor would draw 27.5 amps. The voltages for large powerful motors tend to be relatively high, for example in the 380 Volts to 11,500 Volts range.
For a single-phase induction motor, allow 7 amps on a 240 v for a 1-HP motor. Therefore the formula is: current = 7 X HP x 240 / voltage
Depends on the voltage. If you are running off 120 VAC, a 0.5 horsepower motor would draw 3.1 A.
The current is 1.4 amps, as already stated. The voltage is 45 x 1.4 volts.
Typically single phase motors go up to 10hp. Wouldn't be very efficient at about 100 amps. A 20hp 3 phase motor at 230v pulls 52 amps. The 10hp single phase 230v pulls 50 amps.
There are 746 watts in 1 HP. Watts = amps x volts. It depends on the voltage rating of the motor. Amps = 746/volts = ? need voltage.
more voltage or amps
The amperage of a motor is governed by the voltage that the motor operates on. Without a voltage given, an answer can not be given.
To answer this question the voltage of the motor must be stated.
The voltage of the motor does not determine the power. However it does determine how many Fla... Or full load amp it will have when the motor is at highest speed. Usually the lower the voltage the higher the amps On the same motor. Most motors will have a name plant with this information and you should always get the amount of horsepower motor you need and make sure it will be compatible with your power source.
FLA is the nameplate amperage rating of the motor when it is running at its designed horsepower and on the motors designed voltage. 746 watts = 1 HP. The FLA of a 1 HP motor at 240 volts would be W = amps x volts, Amps = Watts/Voltage. 746/240 = 3.1 amps full load. Overload the motor and the amps go higher, motor running at no load amps are lower than FLA
To answer this question the motor's voltage must be stated and whether the supply voltage is single phase or three phase.
Watts = Volts times Amps. Therefore, if the voltage was 220 volts, the motor would draw 500 amps. If the voltage was 4,000 volts, the motor would draw 27.5 amps. The voltages for large powerful motors tend to be relatively high, for example in the 380 Volts to 11,500 Volts range.
Depends on the voltage.
Need to know what the voltage of the motor is.
Need to know the voltage of the motor.