It means to have an orgasm and it usually refers to men having an orgasm.
uve got to be able to see it 1st fatty
Thank You for this Great Site...*
A normal transformer should not blow the primary side breaker when it is not connected to a load on the secondary. If it does, something is wrong. Check for shorted or burned windings. Make sure that it is indeed disconnected from the load - it might still be connected to something that is also presenting a fault.
The 5 amp fuse has many wattages that it can protect. It depends on the voltage of the circuit that the fuse is protecting. Use the following formula, Watts = Volts x Amps. For example 120 volts x 5 amps = 600 watts, 240 volts x 5 amps = 1200 watts, 480 volts x 5 amps = 2400 watts and 600 volts x 5 amps = 3000 watts.
When the load current exceeds the SCR current rating, SCRs are connected in parallel to share the load current. Further the holding currents of the devices should not be so much different that at reduced load current one of the device gets turned-off because of fall of current through it blow its holding current value.
It will overheat, probably even on no-load. It might blow the circuit breaker or start producing smoke.
Blow my load.
Cover and secure the load.
Thank You for this Great Site...*
they go hard and you blow your load.
Depending on the context it is used in it could mean one of the following:Cocaine (most commonly is slang for cocaine)"Blow job"to "blow" a load - to ejaculate
It will draw over 18 amps and will blow a 15 amp fuse.
A normal transformer should not blow the primary side breaker when it is not connected to a load on the secondary. If it does, something is wrong. Check for shorted or burned windings. Make sure that it is indeed disconnected from the load - it might still be connected to something that is also presenting a fault.
Because the blow their load over the papers they just completed. By Matt Harden
Blow a big load on your monitor and it will reduce the glare comming from it...
Blow a big load on your monitor and it will reduce the glare comming from it...
The elc fuse is for the electronic load control, there is a short somewhere in the system
not exactly sure what is going on, one theory assuming there is no change in the load on the circuit is you are drawing close to the maximum load for the 12 v circuit. probably 10A. the fuse blows due to the heat generated by the electrical current flowing through it. so with a load of 10A it may take an hour for the fuse to get hot enough to blow. if you draw a larger current the fuse will blow quicker and a short will cause it to go instantly.