True
A resistor does not only decrease current in a circuit it can also reduce tension(voltage) if connected in series.
If a 9.0 volt battery is connected to a 4.0-ohm and 5.0-ohm resistor connected in series, the current in the circuit is 1.0 amperes. If a 9.0 volt battery is connected to a 4.0-ohm and 5.0-ohm resistor connected in parallel, the current in the circuit is 0.5 amperes.
It depends on the purpose for installing the resistor. If the intent is to decrease current flow, the resistor must be connected in series with the load. If the purpose is to increase current flow, the resistor must be connected in parallel with the load. To connect a resistor in series, connect the resistor to one side of the power source, in line with the load. This will decrease circuit current flow. To connect a resistor in parallel, connect the resistor between the positive and negative sides of the power source, which will effectively connect the resistor across the load . This will increase current flow through the circuit. However, before connecting a component in parallel, make sure the increase in current flow will not exceed the current rating of the circuit or fuses/breakers will blow.
Multimetres are generaly used to measure the following quantities. Voltage: multimeter is connected in parallel with the Load; Current: multimeter is connected in series with Load; Resistance: the resistor must be taken out of the circuit first, then, the probes from the multimeter are connected across the resistor,
It is used to vary the voltage/current flow in a circuit.
A resistor does not only decrease current in a circuit it can also reduce tension(voltage) if connected in series.
If a 9.0 volt battery is connected to a 4.0-ohm and 5.0-ohm resistor connected in series, the current in the circuit is 1.0 amperes. If a 9.0 volt battery is connected to a 4.0-ohm and 5.0-ohm resistor connected in parallel, the current in the circuit is 0.5 amperes.
-- The current in each individual resistor is (voltage across the whole circuit) divided by (the resistance of the individual resistor). -- The current in any individual resistor is less than the total current in the circuit. -- The total current in the circuit is the sum of the currents through each individual resistor.
in a flashing led circuit connected in series
the current flowing in will be low
:) It's connected together
It depends on the purpose for installing the resistor. If the intent is to decrease current flow, the resistor must be connected in series with the load. If the purpose is to increase current flow, the resistor must be connected in parallel with the load. To connect a resistor in series, connect the resistor to one side of the power source, in line with the load. This will decrease circuit current flow. To connect a resistor in parallel, connect the resistor between the positive and negative sides of the power source, which will effectively connect the resistor across the load . This will increase current flow through the circuit. However, before connecting a component in parallel, make sure the increase in current flow will not exceed the current rating of the circuit or fuses/breakers will blow.
2 A (amperes)
If the resistors are connected in series, the total resistance will be the sum of the resistances of each resistor, and the current flow will be the same thru all of them. if the resistors are connected in parallel, then the current thru each resistor would depend on the resistance of that resistor, the total resistance would be the inverse of the sum of the inverses of the resistance of each resistor. Total current would depend on the voltage and the total resistance
6
A resistor.
The current in each resistor in a series circuit is the same. Kirchoff's Current Law states that the sum of the currents entering a node must add up to zero. The connection between two resistors in a series circuit is a node. The current entering the node from one resistor is equal to the current leaving the node into the next resistor.