Ohm's Law: Current is voltage divided by resistance
110 volts divided by 25 ohms is 4.4 amperes. This is also 440 watts, which sounds low in today's design of hair dryers, leading one to think that the 25 ohms is incorrect or was measured incorrectly.
no.because current always try to flow trough low resistance path.as short circuit has low resistance current pass trough short circuit
Resistance in the circuit makes it difficult for current to pass through.
No. Current and voltage are directly proportional to one-another and both are related to resistance by Ohm's law: V = IR or Volts = Current * Resistance So the current will depend upon the voltage and the circuit resistance by rearranging the above equations: I = V/R Meaning that the current will decrease as circuit resistance is increased if the voltage remains constant.
In a d.c. circuit, voltage drop is the product of resistance and current through that resistance.
voltage and resistance v=ir v=voltage i=current r=resistance in physics right now
The resistance of the component on that branch of the circuit, if the resistance is higher less of a proportion of the total current of the circuit will travel through that branch, however, if the resistance is low a higher proportion of the current will travel through that branch of the circuit. The voltage through each branch stays the same.
The resistance of the component on that branch of the circuit, if the resistance is higher less of a proportion of the total current of the circuit will travel through that branch, however, if the resistance is low a higher proportion of the current will travel through that branch of the circuit. The voltage through each branch stays the same.
Yes In parallel circuit , current entering into the circuit will be divided intodifferent paths ( resistances) . Amount of current flow depends upon the magnitude of resistance applied in the circuit. Total current after passing through the circuit will be the sum of all current through each resistance.
The resistance of the component on that branch of the circuit, if the resistance is higher less of a proportion of the total current of the circuit will travel through that branch, however, if the resistance is low a higher proportion of the current will travel through that branch of the circuit. The voltage through each branch stays the same.
in a parallel circuit resistance decreases increasing the current.
Power = (energy used)/(time to use it)Power dissipated by an electrical circuit =(voltage across the circuit) x (current through the circuit)or(resistance of the circuit) x (square of the current through the circuit)or(square of the voltage across the circuit)/(resistance of the circuit)
As long as the voltage between the ends of the circuit remains constant, the current through the circuit is inversely proportional to the total effective resistance of the circuit.
no.because current always try to flow trough low resistance path.as short circuit has low resistance current pass trough short circuit
lowers the amt of electrical current flowing through it.
Resistance in the circuit makes it difficult for current to pass through.
If you double the voltage in a circuit, the power is quadrupled, assuming the resistance stays the same.
lowest resistance