answersLogoWhite

0

A good number on a megger test should be around 2 megohms.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What is the purpose of a Cable tester?

A cable tester is used to test the electrical connections in a cable or other wired device. There are two ways to test for a connection: continuity test and resistance test. A cable tester can also test for a short by determining voltage.


What are the test for 132 kv cable?

1. phase identification test. 2. Insulation Resistance Test. 3. Conductor capacitance. 4.Conductor Resistance. 4. Outer Sheath Test.


What is allowable structural capacity of pile in pile load test?

allowable structural capacity


Define the thermal resistance of a cable?

No. Conductor resistance is. Cable insulation resistance to ground is inversely proportional to its length. The longer the cable, the more leakage path to ground; therefore, the lower the insulation resistance to ground.


How can I test a coax cable effectively?

To test a coax cable effectively, use a cable tester to check for continuity and signal strength. Ensure the connectors are securely attached and look for any physical damage to the cable. Use a multimeter to measure resistance and impedance.


Using blavier test to check for cable faults?

This is use to locate the ground fault of a single cable. This test is performed with the aid of a low voltage supply with an ammeter or voltmeter. In this test the resistance between one end of the cable C1 and the earth is first measured with the other end, C2 isolated to earth and then with the C2 earthed. Let the two readings be represented by R1 and R2 rep! If r1 and r2 are the conductor resistance of the length of cable at C2 to fault and at C1 to fault rep!, and "r" is the resistance of the fault to earth


How can I use a multimeter to test if a coax cable is live?

To test if a coax cable is live using a multimeter, set the multimeter to the continuity or resistance mode. Touch one probe to the center conductor of the coax cable and the other probe to the outer shield. If the multimeter shows a reading, the coax cable is live.


How many test leads are needed to find resistance?

The test equipment needs two test leads to find the resistance in a circuit.


How to test coax cable for signal?

To test coax cable for signal, you can use a cable tester or a multimeter. Connect one end of the coax cable to the tester and the other end to the device you want to test. Check the tester or multimeter for a signal reading to determine if the cable is functioning properly.


Why are the insulation resistance values higher for test between phase than between phase and ground?

When testing two cables there is twice the the amount of insulation, as opposed to one cable to ground.


What are the steps to doing a cable modem speed test?

Some of the steps for doing a cable modem speed test, include properly configuring the cable modem so that its running optimally, and using a speed test website to test the speed of the modem.


What is the requirement voltage for P.i test?

insolation resistance test