0
When a large load is controlled by a small wire, what device is used?
What else can I help you with?
What is the working principle of a solid state relay?
It is an electronic switching device which controls larger load currents from small currents inside them.
Is a relay considered a load?
The relay's coil(s) would be a load, but the main function of a relay is to act as a switch to control power to a larger load.
What is meant by load in diesel generators?
Any device that uses the generator to supply its operating voltage is electrically classed as a generator load.
What is meant by the term large signal amplifier?
power amplifiers are the amplifier which raise the power levels of the signal.the power amplifier may also defined as a device which converts dc power to ac power and whose action is controlled by the ac input signal. Power amplifiers are also known as "LARGE SIGNAL AMPLIFIER".the term large signal arises because they use large part of load line for their operation,but the small signal amplifiers are use only 10% load line for their operation.
Wave forms of 3 phase fully controlled rectifier for RL load?
for 3 phase r l load phase control rectifier what is the avg value?
What is the working principle of a solid state relay?
It is an electronic switching device which controls larger load currents from small currents inside them.
What is the working principle of relays?
That a small amount of power can control a larger load, or can switch an entirely separate load.
What is working principle of relay?
That a small amount of power can control a larger load, or can switch an entirely separate load.
Is a pressure switch or a relay a load?
A pressure switch is typically considered a control device rather than a load, as it is used to open or close a circuit based on pressure levels. A relay, on the other hand, can also be classified as a control device that uses a small current to control a larger current, but it operates a load by switching it on or off. Thus, while neither is a load in the traditional sense, a relay is more directly associated with controlling loads in electrical circuits.
How much larger is the starting current than the full-load operating?
I am pretty sure that that varies, depending on the specific device.
What is offload device?
an off-load device a a switch where there is no current passing through it when its switched, a isolator is a off load device, a light switch is a on-load device because there is current passing through it when its switched.
Is A load is a device that uses electricity?
The term "load" when used in electrical terminology is a device that uses electricity.
Will a 5 amp device work with a .5 amp power cable?
Yes, the larger cable can carry more load (current) than the other cable.
How does a fixed bore expansion device respond to a reduction in load?
How does a fixed bore expansion device respond to a reduction in load?
How much total load used in single phase?
Single phase loads can go as high as the connected device requires. Of course the higher you go with the load , so goes the equipment to support it. Larger wires sizes, breakers etc..
What is the difference between a streams suspended load and its bed load?
The difference between a suspended load and a bead load is a suspended load consists of the small particles or rock materials that are dispersed throughout the water and easily carried downstream. The bead load consists of the larger particles that are dragged and bounced along near the bottom of the river.
What is the difference between a river's suspended load and its bed load?
The difference between a suspended load and a bead load is a suspended load consists of the small particles or rock materials that are dispersed throughout the water and easily carried downstream. The bead load consists of the larger particles that are dragged and bounced along near the bottom of the river.
