A 'current transformer' (CT) is classified as an instrument transformer, which means it is used to provide a small secondary current that is in proportion to its large primary current, for purposes of metering or protection. At the same time, it electrically-isolates the secondary (metering) circuits from the primary circuits (which are often high-voltage circuits) for the purpose of safety.
use of CT
It is the rated maximum current that can be taken from the transformer. This is equal to the VA rating divided by the output voltage. So a 6 kVA 240 v transformer would have a maximum current rating of 6000/240 or 25 amps.
CT(Current Transformer) is used to measure current flowing in the circuit. Current can be fully drawn or sensed in series condition. That's why , it is connected in series. In parallel , the current is divided; and hence the total current cannot be measured)
A current transformer step downs the current in a power circuit to a lower amperage. A voltage transformer steps down the voltage in a power circuit, typically to 110 volts AC for residential and business use.
Yes, a transformer has eddy currents.
I can't
It is the current transformer core meant for metering.
Transformer is based on the principal of mutual inductance.Induction is produced due to sinusoidal wave form thats why we use Alternating current inspite of Direct current.
A transformer
A transformer can be used to change the voltage to an appliance. The voltage rating of the transformer should be right for the voltages used, and the current rating of the transformer should not be less than the current drawn by the equipment.
In transmission lines there is a massive current, we use CT to make this current measurable i.e. it steps down the current but DT is used to step down the voltage
For higher current applications you would need a power transformer, for lower current applications you would need an adapter transformer.
The ratio would be a 50:1 current transformer.
Excitation current is the current necessary to "turn on" the transformer so it can be used. It's energy that is lost in the use of the transformer. Most of this loss I believe is associated with the hysterisis loop, although some will be lost as eddy currents.
Electrical (alternating current)
use of CT
You can use multiple appliances as long as long as you don't draw more current than the transformer can supply.