A transformer makes and collapses a magnetic Field inside 60 times a second for home power in North America, 50 times a second in Europe.
The building and collapsing of a magnetic field "Induces" a voltage in another transformer winding.
DC current only creates a stable magnetic field and this will not create or induce voltage in the other winding.
Normally covered in grade 5 science where I live.
A transformer only work for ac supply and not dc supply because the frequency for a dc supply is zero leading to zero flux.
Control transformer used only for control supply 110,220, 24,12V AC. But Potential transformer used voltage measurement purpose.
In DC, flow of current is controlled by resistance only where as in AC it is done by Impedance which is combination of Resistance , inductive and capacitive reactances.Reasons:In transformers resistance of the transformer's core windings are very low due to which if you will connect transformer across DC supply then it will draw a heavy current which will burn out is winding and it may damage the equipment too.Transformers works of the principal of Induction (Mutual/Self) that is possible in AC only because in DC there is no induction therefore even if transformer's windings anyhow withstand with DC there will be no voltage output at output terminals of the transformer, therefore it is useless to connect transformer on DC supply.
DC current cannot be used in a transformer only AC will work. A transformer needs the continual build and collapse of the magnetic field to keep the iron core from reaching saturation. Only alternating current will transfer power through a transformer.
A grounding transformer provides a place to connect the distribution system ground where a delta system provides the AC supply.
AC current or DC current can be used in transformers. A transformer is made of two coils of wire, the input coil induces a current into the output coil. Transformers change the voltage either up (step up transformer) or down (step down transformer). The amount of change in voltage is dependent solely on the number of windings in both coils in the transformer. DC transformers work exactly the same way AC transformers do.
Transformers only work on ac supply because it principle is mutual induction. DC supply has constant magnitude whereas AC has alternating magnitude. so we can step up or step down current/voltage in transformer in ac only.
Transformers don't work with DC supplies - they only work on AC.
Transformer is the only device which is capable to stepup or stepdown an ac signal. That's why its used widely in ac supply.
A transformer is a device to convert high voltage AC to low voltage AC & vice-versa. It works on the principle of induction. Since induction occurs only in an AC supply, a transformer cannot work on DC.. So, it is not possible to convert DC supply to AC using transformer. You would need an inverter to convert DC to AC.
You don't. Transformers only work with AC voltage. Their input will be an AC waveform, and their output will be an AC waveform. Other electronics are used to convert the stepped down AC waveform from the transformer to DC.
transformer will work on ac
No transformers only work with AC.
Control transformer used only for control supply 110,220, 24,12V AC. But Potential transformer used voltage measurement purpose.
A transformer steps the voltage of an electrical power supply up or down. The transformer must be correctly designed for the voltage and current levels that it is intended for. Only ac can be used with a transformer, which is designed to work at a particular frequency.
Transformer Power Supply
trf cannot work on dc. the primary flux must vary for induction to occur in the secondary winding. howlunf
A stp-down transformer steps voltage down from a high value to a low value. Transformers only work with AC.