0
Yes, a coil, such as an intrauterine device (IUD), can fall out, although this is relatively rare. Factors that may increase the risk include improper placement, uterine contractions, or expulsion during menstruation. If you suspect that a coil has fallen out or is out of place, it's important to consult a healthcare provider for an evaluation. Regular check-ups can help ensure that the device is correctly positioned.
What else can I help you with?
What is the difference between current coil and voltage coil?
These terms apply to the coils inside a wattmeter. 'Pressure coil' is an archaic term for 'voltage coil', which is connected in parallel with the supply, while the 'current coil' is connected in series with the load.
What is function of pressure coil in a watt meter?
A 'pressure coil' is an archaic term for a 'voltage coil' (UK terminology) or 'potential coil' (US terminology), as opposed to the 'current coil' in a wattmeter. This coil is connected in parallel with the supply, while the current coil is connected in series with the load.
What is meant by a primary coil and a secondary coil?
In a transformer, the primary coil is the coil that has voltage applied to it. The secondary coil is the coil that we take voltage from. Transformers are used to step up voltage, step down voltage, or simply to isolate circuits.
When was Lacuna Coil created?
Lacuna Coil was created in 1994.
When was Icon of Coil created?
Icon of Coil was created in 1997.
Can a coil fall out?
Yes, if you can't feel the dangling string call your doctor to be checked.
How do you tell when a 1993chevy 305 coil is bad?
To determine if a 1993 Chevy 305 coil is bad, check for symptoms like engine misfires, rough idling, or difficulty starting. You can also test the coil with a multimeter; measure the primary and secondary resistance according to the specifications in the service manual. If the readings fall outside the specified range or if there is visible damage, the coil is likely faulty. Additionally, if you notice a weak or absent spark when testing with a spark tester, the coil may need replacement.
Where is the coil wire located on a 1997 Chrysler Sebring LXI 2.5L?
The coil is inside the distributor. There is no coil wire.The coil is inside the distributor. There is no coil wire.
Is it lucina coil or lukina coil?
Lacuna coil
What is the difference between current coil and voltage coil?
These terms apply to the coils inside a wattmeter. 'Pressure coil' is an archaic term for 'voltage coil', which is connected in parallel with the supply, while the 'current coil' is connected in series with the load.
How do you check ignition coil is ok 1997 jaguar xk8?
To check the ignition coil on a 1997 Jaguar XK8, first ensure the engine is off and disconnect the negative battery terminal. Use a multimeter to test the primary and secondary resistance of the coil; typically, the primary resistance should be around 0.5 to 1.5 ohms, while the secondary resistance should be around 6,000 to 15,000 ohms. Additionally, inspect the coil for any visible signs of damage or corrosion. If the readings fall outside these ranges or the coil shows physical damage, it may need replacement.
Where is location of coil wires 8N ford tractor?
The coil wire runs from the coil to the center of the distributor cap.The coil wire runs from the coil to the center of the distributor cap.
What is a prefix for coil?
Did coil
What does the indoor coil do?
The indoor coil acts as an evaporator coil for heating.
What word names the shape of rope or a curled up snake and rhymes with toil?
coil
How do you take the coin tray out of a 2006 vw passat sport dash board if its trapped shut?
The first thing you should do is remove the face plate over the hazard button. Then there are two tabs on the sides of each tray that you can pull outward to yank the tray out. This is not smooth and easy to do and you may have to muscel it out a little bit. There are two removable pieces that may fall out. 1 is the black plastic wheel you can easily click back in. There is also a gray aluminum coil that may fall out as well The coil actually clamps into a small groove in the front of the tray-housing and not on the tray itself This is a loose connection and when you prop the coil into the groove you must carefully place the tray back inline carefully for the coil not too move. This coil is responsible for automatically pushing the tray out when you push to unlock it
How do you change a pick up coil on a 1985 Chevy?
if the coil is on the distributor cap,remove cover then disconnect wires from the coil and remove coil. if coil is on engine then loosen the bolt and remove from coil mount
