answersLogoWhite

0

Yes, a vent can be connected to a gully trap, but it must be done correctly to avoid issues such as siphoning or blockage. The vent helps to equalize pressure and prevent the buildup of gases, ensuring proper drainage. However, it's crucial to follow local Plumbing codes and regulations to ensure the installation is safe and effective. Always consult a professional plumber for specific guidance.

User Avatar

AnswerBot

3w ago

What else can I help you with?

Continue Learning about Engineering

What is the difference of a gully trap drain from a floor drain?

The difference between a gully trap drain and a floor drain is placement. A floor drain is in a floor, a gully trap drain goes on an external wall.


Should the trap be before or after vent?

Depends on your perspective what is before or after. If you're following the direction of the water flow, the trap needs to be before the vent. A water filled trap blocks bad smells/dangerous gasses from entering your home. Putting the vent closest to the sink would bypasses that block. It would also likely cause gurgling because of siphon action trying to pull the water out of your trap (the vent breaks the siphon because its easier to pull air down the vent than to remove the water from the trap) Right = Sink - trap - vent - main drain stack


Can a gully trap be cover?

Yes, a gully trap can be covered, but it should be done with caution. Covering it can help prevent debris from entering and reduce odors, but it’s important to ensure that the cover allows for proper ventilation and access for maintenance. Additionally, the cover should be designed to withstand foot traffic if placed in areas where people may walk over it. Always check local regulations and guidelines for specific requirements regarding gully trap covers.


What is the proper way to run a condensate drain with a trap Does it need a vent?

The condensate drain on the a-coil should have a trap and the trap should be vented for proper operation . The vent should rise above the top edge of the drain pan in the unit. Their should be a capped clean out before the vent.


Is it satisfactory to install a bathtub vent 5 feet down stream to a direct vent strictly for the tub?

Absolutely NOT What is possible (Check local codes) is to install the trap 2 ft from the fixture and the vent 2 ft from the trap BUT if the trap is not easily accessible then your going to have major problems snaking the line

Related Questions

What is the function of a gully tarpwhat is the function of a gully trap?

A gully trap is a way of removing waste water before it is returned to the sewer. The gully trap collects waste water from the kitchen and bathrooms.


What is the difference of a gully trap drain from a floor drain?

The difference between a gully trap drain and a floor drain is placement. A floor drain is in a floor, a gully trap drain goes on an external wall.


What is a gully trap?

Wastewater from your kitchen and bathroom is piped to a gully trap before emptying into the sewer. A gully trap is a basin in the ground with a water seal to prevent foul odours of the sewer reaching the surface. Gully traps are buried in the ground with the tops or surround raised above ground level to prevent ground water entering into the sewer.


What is the use of gully trap in drainage system?

Gully Trap will prevent the back flow and stop Foul smell developed by means of all the waste point collection.


Should the trap be before or after vent or condensation drain?

The trap should be before the vent. The trap is used to maintain a watter barrier to prevent waste water and sewer gasses from entering the home. The vent is use after the trap to allow the water to flow freely in the pipe with out drawing the water from the trap.


What is the dimensions of gully trap?

The dimensions of a gully trap can vary based on local plumbing codes and specific installation requirements, but they are typically designed to fit standard pipe sizes. A common dimension for a domestic gully trap is about 150 mm (6 inches) in diameter for the inlet and outlet pipes. The depth of the trap can range from 300 mm to 600 mm (about 12 to 24 inches), depending on the design and intended use. Always refer to local regulations for precise specifications.


Can a registered plumber install a new gully trap on an exising drain?

Yes, most certainly.


Should the trap be before or after vent?

Depends on your perspective what is before or after. If you're following the direction of the water flow, the trap needs to be before the vent. A water filled trap blocks bad smells/dangerous gasses from entering your home. Putting the vent closest to the sink would bypasses that block. It would also likely cause gurgling because of siphon action trying to pull the water out of your trap (the vent breaks the siphon because its easier to pull air down the vent than to remove the water from the trap) Right = Sink - trap - vent - main drain stack


Is the pee trap above or below the vent?

I BELIEVE: In a horizontal run, the p-trap must be below the vent. Otherwise, the vent may fill with water, creating a blockage, which would then syphon the water from the p-trap causing odors and health concerns from sewer gas. On a horizontal run, the vent must come off the run (presumably with a "wye") where the vent run is above the center line of the drainage run, thus the p-trap is lower than the vent...


Can a gully trap be cover?

Yes, a gully trap can be covered, but it should be done with caution. Covering it can help prevent debris from entering and reduce odors, but it’s important to ensure that the cover allows for proper ventilation and access for maintenance. Additionally, the cover should be designed to withstand foot traffic if placed in areas where people may walk over it. Always check local regulations and guidelines for specific requirements regarding gully trap covers.


What is the proper way to run a condensate drain with a trap Does it need a vent?

The condensate drain on the a-coil should have a trap and the trap should be vented for proper operation . The vent should rise above the top edge of the drain pan in the unit. Their should be a capped clean out before the vent.


Is it satisfactory to install a bathtub vent 5 feet down stream to a direct vent strictly for the tub?

Absolutely NOT What is possible (Check local codes) is to install the trap 2 ft from the fixture and the vent 2 ft from the trap BUT if the trap is not easily accessible then your going to have major problems snaking the line