To test a stator on a Ski-Doo, first, disconnect the electrical connectors and use a multimeter to measure the resistance between the stator's windings. Check for continuity between the windings and ensure there's no short to ground by measuring resistance from the windings to the stator case. Additionally, you can test the output voltage by starting the engine and measuring the AC voltage at the stator's output wires, comparing it to the manufacturer’s specifications. If the readings are outside the specified range, the stator may need replacement.
An electric motor has a stator and a rotor. The stator does not move. The rotor rotates inside the stator.
when current is passing through the stator windings of motor magnetic field is develop ,due to it emf is produced inside the stator windings,that emf is further cuts the emf across stator due to which current flowing inside the rotor.
The Spanish word for "stator" (motor part) is estator. But the word is also used for an "estate" of land.
shaft, windings, ball bearings, armature, stator, commutator, brushes, terminals, case.
Stator is part of rotating mechanical device thats sorrounds the rotor to rotate it through the induced magnetic field while the Rotor, is the one who is rotated by produced magnetic field in the stator,.
check coils stator and all connections test procedure check coils stator and all connections test procedure
nope....stator as in the alt? dont do it. this was a test before the computer days... you will surge/ zap the comp. or did you mean starter? either way the answer is no
yes for continuity
Skidoo xp 800
Th eplural form of skidoo is skidoos
skidoo is a type of snowmobile, like a Chevy is a type of car.
With a mutimeter test between each lead (usually yellow in color), the reading should be approximately one (1) ohm. or close.
An electric motor has a stator and a rotor. The stator does not move. The rotor rotates inside the stator.
23 -- Skidoo - 1930 was released on: USA: 9 June 1930
With a mutimeter test between each lead (usually yellow in color), the reading should be approximately one (1) ohm. or close.
A typical Skidoo snowmobile can weigh around 400-600 pounds, depending on the model and specific features.
you need to test with ohm. meter... there are resitance test. and could also be output test using a volt meter. you will need a service manuel to get sepect.....for the corrct make ,model, and year,,,,... what is your problem that your having.....