1:The strenght of the main magnetic Field. Determined by the strenght of the field magnets in a permanent magnet machine, or by the number of turns of wire on the field coils and the current through the coils in a wound field machine.
2: The number of armature conductors connected in series, which cut the main magnetic field. Determined by the number of turns on armature coils and weather the armature is lap or wave wound, which determines the number of armature conductors connected in series.
3: The speed at which the armature conductors cut the main magnetic field. The faster the armature cuts the magnetic Field, the higher will be the value of the voltage generated in the machine
It depends upon the Generator system voltage. For 3 Phase, 600 Volt system, it will be 73 Amps For 3 Phase, 480 Volt system, it will be 90 Amps For 3 Phase, 208 Volt system, it will be 208 Amps
a generator is built in three phases
The number of stator poles used for battery charging in a 3-phase stator assembly typically depends on the design and application of the generator or alternator. However, in many cases, a 3-phase generator will have either 6 or 12 poles, which allows for effective charging of batteries by generating alternating current (AC) that can be rectified to direct current (DC) for charging. The specific number of poles can vary based on factors like the desired output voltage and frequency.
The theory of converting AC to DC using a 3-phase induction motor and a DC shunt generator involves utilizing the induction motor to mechanically drive the shunt generator. When the induction motor is powered by a three-phase AC supply, it operates and drives the rotor of the connected DC shunt generator. This generator then converts the mechanical energy into electrical energy, producing a DC output. The process allows for efficient conversion of AC to DC, leveraging the motor's mechanical properties and the generator's electrical characteristics.
To connect a compressor with a 240-volt 2-wire feed to a 3-wire generator, you will need to utilize two of the generator's wires (typically the two hot wires) and leave the neutral wire disconnected. Ensure that both wires from the generator are connected to the compressor's terminals according to its wiring diagram, ensuring proper polarity. Additionally, make sure the generator's output matches the compressor's voltage and current requirements to avoid damage. Always follow electrical safety guidelines and consider consulting a qualified electrician if unsure.
DC generator is used to produce direct current. The basic DC generator have four basic parts 1. A magnetic field 2. A single conductor or loop 3. A commutator 4. Brushes
It depends upon the Generator system voltage. For 3 Phase, 600 Volt system, it will be 73 Amps For 3 Phase, 480 Volt system, it will be 90 Amps For 3 Phase, 208 Volt system, it will be 208 Amps
3 factors that affect the speed of an enzyme catalysed reaction are: .Temperature .Enzyme Concentartion .Substrate concentration
Yes, you can make a 3 volt wind generator by selecting an appropriately rated DC motor and coupling it with wind turbine blades. The rotation of the blades will generate electricity in the motor, which can then be rectified and regulated to output a stable 3 volts. It's important to consider the wind speed and power requirements when designing the wind generator to ensure it can consistently produce 3 volts.
The 3 factors that affect the history of any nation have always been a) Economy b) People and c) Wars ofcourse.
- Heredity - Environment - Situation
Angle and what are the others
a series generator is 3 or 5 generator connected together
Altitude, temperature and humidity.
Composition, heat, and pressure.
Not on small household generators as they are only single phase. On large industrial 3 phase machines over 100 KW there are internal taps that can be changed depending on the generator coil configurations to select a variety of voltages.
== ==