0
What else can I help you with?
When applying loads to the primary distribution center you can close all of the circuit breakers on the connected secondary distribution center at once?
false
How many ground fault interrupter GFCI circuit breakers are there in the circuit breaker panel of the secondary distribution center?
2
What is the function of an LBB relay?
A local breaker backup relay is used to check the operation of distribution circuit breakers and to trip the feeder circuit breaker if the distribution circuit breaker fails to trip on an overload.
Can some body show me Electrical circuit diagram of Molded case circuit breakers?
Circuit breakers do not have circuit diagrams. The breakers have an input where the distribution voltage is applied and an output where the load is applied. If you want to know what is inside a breaker, the electrical terminology to use is "shop drawings" of the specific breaker that you need information on.
What two things happen when the number of appliances connected to the multiple socket is increased?
The amperage of the circuit increases and the voltage drop across the appliances will tend to increase.
What is a load side of the panel?
The load side of a panel refers to the section where the circuit breakers are connected to distribute electrical power to various devices and appliances within a building. It is where the electrical load is connected after passing through the circuit breakers for distribution.
When applying loads to the primary distribution center you can close all of the circuit breakers on the connected secondary distribution center at once?
false
How do you identify the circuit breaker?
circuit breakers are connected in series manner in the circuit.
When would you need to use westinghouse circuit breakers?
You need these types of circuit breakers when using 240 volt power rather than 120 volt. Large appliances such as a dryer require these larger circuit breakers. Other appliances such as stoves and some water heaters also require them.
Circuit breakers are used for what?
Circuit breakers prevent excessive current from flowing in the circuit by "tripping" when the current exceeds the circuit breaker rating. This causes the current to be cut off, and is used to protect the wiring as well as the appliances.
How many ground fault circuit GFCI circuit breakers are there in the circuit breaker panel of the secondary distribution center?
2
Appliances connected so that they form a single pathway for charges to flow are connected in a?
Circuit
What do fuses and circuit breakers protect circuits from?
They protect the downstream components from spikes in the eletrical system.CommentFuses and circuit breakers do not protect against 'spikes', which are near-instantaneous voltage increases. Fuses and circuit breakers are overcurrent protection devices, which protect appliances against excessive current due to overloads or short circuits. CommentFuses and circuit breakers are used to protect the wire feeder that supplies the load. A load could be connected to a circuit that would cause an increase of amperage above what the wire is rated for. If this condition happens the fuse or circuit breaker will open the load from the supply service.
What is the difference between a service-entrance switchboard and a distribution switchboard?
Service-Entrance switchboard has circuit breakers that sends the incoming high voltage from the transformer to different distribution switchboards around the building that goes to different power operating machines or appliances. The service Entrance switchboard have large pumping circuit breakers since it has to do with large voltage. when electricity enter the service entrance circuit breaker it is at 480V + and when it goes into the service entrance switchboard it reduces the voltage to proper voltage for the building and sends it to the distribution switchboards.
How many ground fault interrupter GFCI circuit breakers are there in the circuit breaker panel of the secondary distribution center?
2
What is the function of an LBB relay?
A local breaker backup relay is used to check the operation of distribution circuit breakers and to trip the feeder circuit breaker if the distribution circuit breaker fails to trip on an overload.
Can some body show me Electrical circuit diagram of Molded case circuit breakers?
Circuit breakers do not have circuit diagrams. The breakers have an input where the distribution voltage is applied and an output where the load is applied. If you want to know what is inside a breaker, the electrical terminology to use is "shop drawings" of the specific breaker that you need information on.
