The total resistance of a circuit is the sum of the supply's internal resistance and its load resistance, because they are in series with each other. This is true regardless of the magnitude of, or the variation in, the current.
Cell constant(C) = Resistance(R) X Specific Conductivity(K)
due to the electrolyte present between the two electodes of the cell
Internal resistance
i=F*sum(zi*Ci) where, i is the current density, F is Faradya's constant, zi is the velence of species i, Ci is the concentration
Ohm's law gives the relationship between current, voltage, and resistance. The law states that I=V/R, where I is current, V is voltage, and R is resistance. Source: university digital fundamentals
I think that the relation is R = k/L where R is the resistance, L is the length of the wire, and k is the constant of proportionality.
The higher the viscosity, the lower the flow-ability of a material.(Viscosity=internal resistance to flow)
Both are same
ghandi's entire ethos was about passive resistance
ohm
A non-ohmic resistor doesn't have a constant resistance. A ohmic resistor has a constant resistance.
In a circuit with constant voltage, the relationship between current and resistance is inversely proportional. This means that as resistance increases, the current flowing through the circuit decreases, and vice versa.
Cell constant(C) = Resistance(R) X Specific Conductivity(K)
A volt is the unit of measurement for electrical potential difference, while an ampere is the unit of measurement for electrical current. The relationship between them is defined by Ohm's Law, which states that voltage equals current multiplied by resistance (V = I x R). In other words, voltage is proportional to current when resistance is constant.
Ohm's Law: voltage = current * resistance. If resistance is a constant, then voltage is directly proportional to current.
If resistance is doubled in a circuit with constant voltage, Ohm's Law (V=IR) states that current (I) would be halved since the voltage is constant. This is because the relationship between resistance and current is inversely proportional.
voltage depend on current and resistance r.p.m depend on no of pole