please you give me reply to answer.
I assume a 3 phase, AC induction motor. A star delta starter or a soft starter can be used. A soft starter is better compared to a star delta starter, but it is more expensive.
With a transformer...
In manual star delta starter, the change over from star to delta does not happen automatically. The operator or user puts on the starter, and after few seconds he pushes a lever or handle to change over to Delta. In automatic method, change over happens from star to delta using an automatic preset timer.
delay timer
The use of a star delta starter is for motor control only and not resistive heating loads. This type of starter is used to dampen the inrush current by using a lower voltage to start the motor.
Check your Delta connections first if the phases is corresponding, and check your Circuit Breaker if it sufficiently rated.
On a star delta starter a motor overload or a motor going to ground and cause a short circuit will cause the overload protection to trip. These overloads have to be reset before the motor can be restarted.
The maximum acceptable tan delta value of a 132 KV SF6 circuit breaker is typically around 0.3. This value indicates the insulation quality of the circuit breaker and should be within the specified range to ensure safe and reliable operation. If the tan delta value exceeds this limit, it may indicate potential insulation issues that need to be addressed.
I assume a 3 phase, AC induction motor. A star delta starter or a soft starter can be used. A soft starter is better compared to a star delta starter, but it is more expensive.
The three common types of starters used in a three phase circuit are DOL (Direct-On-Line) starter, star-delta starter, and soft starter. DOL starters provide full voltage to the motor upon start, which can cause high inrush current. Star-delta starters initially start the motor in a star configuration to reduce current, then switch to delta for full speed. Soft starters gradually ramp up the voltage to the motor to reduce inrush current and mechanical stress on the motor.
The Star-Delta control circuit diagram shows the delta contact and the main contact.
What do you mean by a 'parallel delta' circuit -is there such a connection.
With a transformer...
With a transformer...
connected to the starter
No difference. Y is used as a symbol to indicate the star connection.
In manual star delta starter, the change over from star to delta does not happen automatically. The operator or user puts on the starter, and after few seconds he pushes a lever or handle to change over to Delta. In automatic method, change over happens from star to delta using an automatic preset timer.