Yes, the resistance is directly proportional to length of wire and inversely proportional Area, hence when Length of wire increases the resistance also increases and when Area increases the resistance decreases. This means a thick wire has least amount of Electrical resistance.
Generally a larger diameter copper wire would create the least resistance to electron flow. Copper is the most conductive and is widely used.
They provide a positive shut off and offer the least amount of resistance to flow when fully open.
The soil vent in the waste line breaks the siphon that would drain traps and toilet bowls by providing a path of least resistance for air pressure. see link
A path that is made for an electric current is called a circuit. The two main components in a circuit are the load and a source which are combined with conductors and as a whole form a circuit.
int
The branch with the highest resistance will have the least amount of current flow in a parallel circuit. This is because current follows the path of least resistance, so more current will flow through branches with lower resistance.
In a parallel circuit, each branch has the same voltage but different current flows. The branch with the highest resistance will have the least amount of current flow, as current follows the path of least resistance.
The higher the resistance, the less current will flow through it (while the supply voltage remains constant).
the least amount would be 3
Amount of resistance
The branch with the highest resistance in a parallel circuit will have the least current flow. Ohm's Law: Current = Voltage divided by Resistance
A conductor has the least amount of resistance among the options provided. Conductors have low resistance due to their ability to easily conduct electricity through the movement of electrons. Conversely, insulators have high resistance, while semiconductors and resistors can have varying levels of resistance depending on their composition and structure.
Superconductor wire would have the least resistance. Superconductors have zero electrical resistance when cooled to very low temperatures, allowing for an efficient flow of electrical current without any loss of energy.
I would guess the SR-71 does.
The material that would produce the least amount of smoke when burning is glass.
A smooth radius sheet metal elbow typically creates the least amount of resistance compared to sharp elbows or mitered elbows. This design allows for a more gradual change in direction of airflow, reducing turbulence and pressure drop.
No, current does not flow through a circuit by taking the path of least resistance. Instead, current flows through all available paths in a circuit, with the amount of current in each path determined by the resistance of that path.