On a 2000 Isuzu Rodeo, the knock sensor is typically located on the engine block, near the intake manifold. It is often found on the driver's side, below the intake manifold, and secured with a bolt. To access it, you may need to remove some components for better visibility. Always refer to the vehicle's service manual for precise location and procedure.
The knock sensor is located on top of the engine block underneath the intake.
i need to locate knock sensor on a 2000 infiniti g20
Where is the knock sensor on a 2000 monti carlo ss 3.8l
how to replace a knock sensor on a 2000 Chevy 6.0 step by step
need change knock sensor 2 bank 2 in 2000 lexus rx300
no, it is not.
If somebody knocks on the front door of the Subaru, the KNOCK sensor, sets off the KNOCK Alarm....LOL
the knock sensor is under intake, must remove intake and it is under two coolant lines.
Underneath the intake manifold there will be two knock sensors
donde esta colocado el knock sensor en una Chevy silverado 2000
The knock sensor is on the right side of the motor on the block .It runs under the manafold.I can not get the retaining clip off.MIKE
you have to take the dash off to get to it...