0
the tention pulley bolt is not stuck. It is supposed to be that way take a 1/2 " or 3/4 rachet or breaker bar and put it in the square hole and use the breaker bar to get leverage to move the tention bar so that tention is off the belt to rmove belt and do the same to install belt
What else can I help you with?
What method is used to tension the drive belt?
Move a pulley
How do you install HST drive belt Kubota T1570?
To install the HST drive belt on a Kubota T1570, first, ensure the engine is off and disconnect the battery for safety. Remove the mower deck to access the drive belt easily, followed by loosening the tensioner pulley to relieve tension on the old belt. Install the new belt by routing it according to the diagram found in the operator’s manual, ensuring it sits properly on all pulleys. Finally, re-tension the pulley, reassemble any removed components, and reconnect the battery.
How do you tighten the serpentine belt on a 1896 Mercedes 190E 2.3?
There is a belt tension pulley with a slot for a 1/2 " drive ratchet release tension (MIGHT HAVE TO USE A CHEATER BAR) install belt. Done deal.
Where is a tensioner pulley on a 1981 Oldsmobile omega?
When looking at the engine from the front, the tension pulley is the only wheel on the drive belt that has the belt on the inside of it. All of the other pulleys have the belt going around the top of the pulley. The tension pulley has a bolt that can be loosened and then tightened to remove the drive belt.
What kind of tool do you use to loosen tension pulley on a 2002 cavalier?
You would typically use a serpentine belt tool or a breaker bar with the appropriate socket to loosen the tension pulley on a 2002 Cavalier. These tools help you apply enough force to release tension on the pulley so you can easily remove or install the serpentine belt.
WHAT PULLEY DO I loosen to get single drive belt on?
If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.
A pulley on front of motor is loose but i don't know the name of it it's right above the tension pulley?
If it does not drive anything it could be an idler pulley.
What is a belt tension pulley?
Most cars now have a serpentine belt that drive the alternator, water pump, power steering unit, etc. The belt tension pulley is a spring loaded pulley that keeps the proper tension on all these units. It can be moved to release the tension in order to remove the belt.
How do i loosen the tension belt on a 98 cavalier 2.2?
The tension pulley has a 3/8" square hole in it. Using a 3/8 drive ratchet or breaker bar, simply put it in and pull the tension pulley.
How to change an alternator in a 3126 cat engine?
remove the old one, remove the drive pulley. install the drive pulley on the new alternator,lock the shaft with an allen or drill bit thru the housing hole,torq the drive pulley nut, install it like the old one was installed.
How do you adjust tension on 1054 cub cadet deck drive belt?
I have a 1054 and just put a new drive belt on it. It has a spring loaded belt tension pulley and there is no adjustment. Check and see if the spring has broken or come off the pulley.
How do you replace a fan belt on a mercury mystique?
fans are driven electronically no belt. The serpentine belt is taken off by taking the tension off at the tensioner and replacing by following the pattern on your strut tower.
