The best way to do that is open the door borrow another car, and drive into it its the fastest way to remove the door, then the rest is simple
Use hammer.
open the door then drive into it with another car and it should remove it safely if not just use a hammer
Is in the drivers handbook.
The switch is down beside the drivers door sill..its a soft rubber button, you cant miss it! :)
take window adjuster case of...remove the nut, is there a special tool to remove the mirror unit. There is a thread on the new mirror which goes into the door
If its a 98 60sx mk1 punto then you have to take out the screws at the bottom of the door pockets then use a flat screwdriver to pop it out from the bottom workin your way to the top an lift it round the lever that opens the door then over the locking pin.
Inside drivers door, on floor pan(pull back carpet) find square plastic cover, lift to reveal chassis no.
To remove the window switch on a Fiat Punto front door, start by using a flathead screwdriver to gently pry off the trim panel surrounding the switch. Once the panel is removed, locate the screws securing the switch and unscrew them. Then, carefully disconnect the wiring harness attached to the switch. Finally, you can pull the switch out from its housing.
Fiat Punto was created in 1993.
The Fiat Punto is manufactured by the company Fiat. Fiat is an Italian manufacturing company. The manufacturing of the Fiat Punto started in 1993 and is still currently being produced.
Tyre Pressure for Fiat Punto 1.2cc 8V 3 door is 29psi (front) or 2.0 bar 28psi (rear) or 1.9 bar for normal use.
To change the driver's wing mirror on a 2007 Fiat Punto, start by carefully removing the interior door panel to access the mirror's mounting screws. Disconnect the electrical connector if your mirror has power features. Unscrew the old mirror from the door and replace it with the new one, ensuring it's securely fastened. Finally, reconnect the electrical connector (if applicable) and reattach the door panel.