To remove the plastic trim from an Audi A3 tailgate, start by using a flat plastic trim removal tool to gently pry off any clips holding the trim in place. Be careful to work your way around the edges to avoid breaking the clips. Once the clips are loosened, carefully pull the trim away from the tailgate, ensuring you disconnect any wiring for lights or sensors if applicable. Always consult the vehicle's service manual for specific instructions related to your model year.
big hammer
First you need to remove the trim bezel around the handle on the outside of the tailgate. Then remove the three bolts on the inside of the tailgate,that hold the handle in place. Next remove the latching mechanism rods from the handle,and remove the handle from the tailgate.
glue it with good glue from Menards
You have to remove the the tailgate trim to access the bulb.
If you are talking about a plastic trim, the best way to remove it is by spraying a wax remover product like McKee's 37 Wax Remover for Plastic, directly on a towel and gently applying it to the plastic trim. It is recommended that you use a trim protectant product after removing the wax, to protect the plastic trim.
Just take it to a shop. Nobody gives a sh*t.
# Remove # Take off the wiper arm. # Remove the plastic cover at the base of the rear wiper assembly (arm+wiper blade) to expose the single nut holding the wiper assembly onto the motor. # Remove the nut, then remove the wiper assembly. # Remove the rubber boot surrounding the wiper attachment. ## Open the tailgate and remove the plastic strap that allows you to close the tailgate from inside the car (two screws) ## Pry off the two plastic covers on the top of the trim near the glass. When you remove the smaller one, a screw will appear ... remove that screw. ## Now start pulling the trim away from the door, starting at the top. It is held to the frame via pressure clips. You'll notice that the bottom half of the trim will release as you start angling the top half away from the frame (no pressure clips at the bottom). # Now remove the interior trim on the tailgate: # From here it's pretty easy... # Disconnect the motor being careful NOT to damage the plastic connector. (prying apart works well by rotating a small flathead screwdriver) # Remove the metal bracket by take the three screws out of the frame. # Take the motor off the metal bracket (two screws) and swap motors. # Go to local pre-school and find a baby, then beat it. Reverse the process to put it back together.
To remove the tailgate inner panel on a C4 Grand Picasso, start by opening the tailgate and carefully prying off any plastic covers or trim pieces to access the screws. Remove the screws securing the panel, then use a flat tool to gently detach the clips holding the panel in place. Once all fasteners are removed, pull the panel away from the tailgate, being cautious of any wiring connected to lights or sensors. Finally, disconnect any wiring harnesses before fully removing the panel.
pull off engine "weatherstripping" at back of engine bay, in front of Battery. remove plastic pieces covering battery area remove the passenger side plastic trim piece near the windshield wipers (it has three clips that are undone with a turn of a Phillips screwdriver. Battery will then be accessible to remove with a 10mm socket. reinstall is reverse of removal.
2 torix screws in the handle wells, then pull, it is clipped into holes if you do this carefully the clips will not break
Try these instructions: http://www.humanspeakers.comaudidoors-89.htm?
Just use a screwdrive to pull the trim out. They are just clipped in.