To remove the rear seats from a Peugeot 307 CC, start by locating the bolts securing the seat base; these are usually found at the front edge. Use a socket wrench to remove the bolts, then lift the seat base upward and out. For the seat back, check for any clips or bolts at the base and sides, unfasten them, and then pull the seat back upwards to detach it. Always consult the vehicle's manual for specific instructions and safety precautions.
To remove the seats in a Peugeot 307CC, start by sliding the seat forward to access the rear bolts. Use a socket wrench to remove the bolts securing the seat to the floor. Once the bolts are removed, gently lift the seat out while disconnecting any electrical connectors if present. Finally, repeat the process for the other seat if necessary.
You grab the rear gentley, then pull down your pants... then you might figure out the rest.
To remove the rear seats on a Peugeot 307cc, start by locating the release mechanisms, usually found at the base of the seat cushion. Lift the front of the seat cushion to release it from the clips and then pull it out. For the seat back, locate the bolts or screws securing it to the vehicle's frame, remove them, and then gently lift the seat back upwards to detach it. Always refer to your vehicle's manual for specific instructions and safety precautions.
To remove the rear seats from a Peugeot 307CC, start by locating and removing any screws or bolts securing the seat base, typically found at the front or underneath. Next, pull the seat base upward to detach it from the clips holding it in place. For the seat backs, check for any release mechanisms or bolts at the base and remove them. Finally, gently lift the seat backs out of their positions.
remove the drawer in the center console near the back seats and then remove the cover that has the two small air vents by pulling it towards the rear seats. Will be visible the stud bolt.
fitting rear bulb peugeot expert van
Remove seats
To remove the rear seats on a Peugeot 406 Coupe, start by locating the seat base clips or bolts, usually found at the front or sides of the seat. Release any clips or unscrew the bolts to detach the seat base, then lift it out. For the backrest, check for bolts or clips at the base or sides, remove them, and then carefully lift the backrest out of its mounting points. Always consult the vehicle's manual for specific instructions and safety precautions.
TNT
they are connected at the rear of each wheel, and disconneted under the rear passenger seats and then lift flap under carpet and remove plastic lid, and they are both there, you have to lower petrol tank to remove sensor cable, and replace new ones. but i would leave if they are not faulty.
Chainsaw
There should be a strap at the rear bottom base of the seats. Pull this strap and tip forward. The seats will lift out.