answersLogoWhite

0

To replace the master cylinder on a Volvo 240DL, first, ensure the vehicle is on a level surface and the engine is off. Disconnect the negative battery terminal, then remove the brake fluid from the reservoir. Unbolt the master cylinder from the brake booster, disconnect the brake lines (using a line wrench to prevent stripping), and then remove the old master cylinder. Install the new master cylinder by reversing the removal steps, making sure to properly bleed the brake system afterward to remove any air.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

What is the spark plug diagram to a 1988 Volvo 240DL?

The spark plug diagram for a 1988 Volvo 240DL typically follows the firing order of 1-3-4-2, with the cylinder arrangement as follows: Cylinder 1 is at the front (near the timing belt), followed by Cylinder 3, then Cylinder 4, and finally Cylinder 2 at the rear. The spark plug wires should be connected accordingly: Cylinder 1 to the first terminal, Cylinder 3 to the second, Cylinder 4 to the third, and Cylinder 2 to the fourth. It's always best to consult a repair manual for precise diagrams and specifications.


Diagram for firing sequence of an 1989 Volvo 240dl?

2431


Cost to replace a master cylinder on a Volvo?

I can tell you that I am paying $600 for a new master cylinder (parts and labor) for my 2004 XC90. Supposedly the part is not remanufactured, but new (although I haven't verified that yet.) I was told ~2 hours labor.


Have a Volvo 850have some clutch problems the clutch pedal is stuck on the floor and cant enter into the gears?

Replace master and slave cylinder, then bleed hydraulics.


Where is the starter inhibitor switch on a 1990 Volvo 240dl?

Where is the starter inhibitor swith on a volvo 1993 260 GLE i ?


Where is the starter relay located on a 1986 Volvo 240dl?

I believe there isn't one.


Does an 1984 Volvo 240dl have an integal regulator?

My 1982 Volvo 244GL had a voltage regulator in the back of the alternator so I assume your 1984 is the same


Where is the fuel pump located on a 1988 240DL Volvo?

Why does my car kick over but wont start?


What size wrench to remove Volvo 240DL oil plug?

7/8 Inch Socket:


Where is the temperature sending unit located on Volvo 240DL?

on left rear side of engine block


Is synthetic 5W30 the best engine oil to use for your Volvo 240DL?

Best is what the manufacturer recommends.


Does a 1990 Volvo 240DL use a 1 wire alternator for a 12 volt system?

mikehunt